2006 pontiac vibe interior light switch

Hello,
I'm looking for the interior light switch on a 2006 pontiac vibe. The reason that I'm looking is that there are supposed to be two dome-light wires there that i can tap and finally finish my alarm wiring project,one is RED / yellow and requires a 775 relay and the other is red and black, but i can't seem to find them.
Bulldogsecurity says:
DOMELIGHT SUPERVISION      RED / BLACK (-) or RED / YELLOW (-), Requires Part # 775 Relay      @ INTERIOR LIGHT SWITCH

the12volt just says it triggers with an unlock from the unlock wire, but i have a base model and none of this wiring was in my car.

Here Are some pics:


as you can see, all i have here are 2 greens, a black, a WHITE/ red, and a WHITE/ black. There seems to be an error in the wiring diagram? or am I mistaken?



This connector on the left has some red wires, but they're all connected to the mirror controls:


Thanks

This info from AudioVox :
Domelight Super      RED / WHITE  (-)      AT THEFT MODULE BEHIND RIGHT SIDE
                                                                       OF DASH NEXT TO GLOVEBOX - Pin 3

-------------
Soldering is fun!

One reason for your problem is that the switch panel you showed controls the door mirrors and the instrument panel gauge illumination, naught to do with dome lights.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

kreg357 wrote:

---

This info from AudioVox :
Domelight Super      RED / WHITE  (-)      AT THEFT MODULE BEHIND RIGHT SIDE
           OF DASH NEXT TO GLOVEBOX - Pin 3

---

I have a base model, there is no theft module in my car. So that rules that out too :/

howie ll wrote:

---

One reason for your problem is that the switch panel you showed controls the door mirrors and the instrument panel gauge illumination, naught to do with dome lights.

---

Right, Someone told me that mine did have that control though. Even my manual.(LOL they don't even make a true base-model manual) I was hoping that I was wrong. I can't seem to find this light anywhere else, either.

I haven't done a Vibe yet, but I have done plenty of corolla's which I believe is the same car...Corolla, matrix and vibe. RED / Yellow in the drivers running board can be used as a All door trigger and dome supervision. I think there are 2 or 3 RED / yellows, so test.

flobee4 wrote:

---

I haven't done a Vibe yet, but I have done plenty of corolla's which I believe is the same car...Corolla, matrix and vibe. RED / Yellow in the drivers running board can be used as a All door trigger and dome supervision. I think there are 2 or 3 RED / yellows, so test.

---

thanks, but whan you say running board, do you mean the bunch of wires along the side, running from the kick panel? there's one in there haven't seen one anywhere else. I'll look around and see if there are more and let you know.

Yeah, Thats what I ment. The bundle or 2 of wires that run from the drivers kick panel to the rear of the car.

This thread is too long. If this is a Corolla and the dome light has a time delay off but shuts down immediately when you LOCK the doors then the switched neg (i.e. neg when doors are open, open circuit when doors are locked) is your all door trigger and dome light control isn't required.
This will will run from the fuse box up an "A" pillar to the light. Job done.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

so I just have to figure out how to pop off the pillar and the wire should be there then? ok i'll try that.

The Drivers 'A' pillar also has the Dome light wire, but I "believe" it is RED / white there. I only used that wire 1 or 2 times. I found out about the other wire in the drivers running board shortly later. Since I goto the running board for brake and parking lights and in the drivers kick for door locks and ground, its easier for me. This way I get all my wires in one area.

yes, but there's only one RED / yellow wire in the running board. i've tried using this but it didn't work, and i can't properly test it till i replace my DMM's battery. i'll try again just to make sure though.

well just tested it and although my DMM battery is failing, it would at least tell me if there were life on the wire when the domelight was on or off, and i got nothing, so that wasnt it.

sorry for triple posting, but i'm too young of a user to edit posts, I'm trying to find a wire to use before i actually have to go into pillar A, because that would mean i'd have to take the dashboard off to take it off.
Big bummmer.

If this vehicle is basicly a Toyota shouldn't it be coming off the fusebox in a 3-5 pin white plug?

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

howie ll wrote:

---

If this vehicle is basicly a Toyota shouldn't it be coming off the fusebox in a 3-5 pin white plug?

---

sorry I have no idea, this is the first real electric job i've done on a car.

managed to tap the two triggers behind the speedometer. Thanks Flobee!!!!

Hi laserbeak43.
I am running in your same situation. I have my alarm connected except for the domelight supervisor wire. Could you explain how found this cable. Thanks! ! !

jonnyt822 wrote:

---

Hi laserbeak43.
I am running in your same situation. I have my alarm connected except for the domelight supervisor wire. Could you explain how found this cable. Thanks! ! !

---

sorry, but i didn't find this cable. I did, however find a very easy place to tap the driver door and alldoor triggers. do you have a 2006 vibe as well?