2014 toyota tacoma
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=135979
Printed Date: May 04, 2024 at 1:02 PM
Topic: 2014 toyota tacoma
Posted By: mmchugh
Subject: 2014 toyota tacoma
Date Posted: February 02, 2014 at 4:42 PM
I'm looking for a wiring diagram for a 2014 Toyota Tacoma double cab with manual transmission to install a python 4206 remote start. I've found info for a 2013 but I can't confirm if they are the same. I purchased a subscription on Toyotas TIS website but I cant find what I'm looking for. If anyone could help that would be sweet.
Thanks,
Mike
Replies:
Posted By: smokeman1
Date Posted: February 03, 2014 at 6:29 AM
Try this site sign p is free and always verify with a DMM.
https://www.readyremote.com/main.asp?action=select&yr=27069&product=Remote Start&make=Toyota&model=Tacoma
------------- When all else fails, Read the Instructions
Support the12volt.com Make a Donation
Posted By: mmchugh
Date Posted: February 03, 2014 at 7:23 AM
smokeman1 wrote:
Try this site sign p is free and always verify with a DMM.
https://www.readyremote.com/main.asp?action=select&yr=27069&product=Remote Start&make=Toyota&model=Tacoma
Thanks! I'll verify with a DMM
Posted By: hoe_nah808
Date Posted: February 23, 2014 at 1:51 PM
quick question if anyone can answer. going to install a python 5706P in my 2014 tacoma. I do NOT want to use the remote start function. that being said which wires do I not use in my install? I have a list of what i dont need if anyone could help me verify if i am correct
24pin harness
Ignition 2/flex output
status output
activation input
tach input
neutral safety/ parking brake input
brake shutdown
any more i dont need?
Posted By: harryharris
Date Posted: February 23, 2014 at 3:19 PM
H2/
Violet POS door trigger input.
Violet / YELLOW 2nd starter NEG output
Gray/black diesel WTS input
Orange ACC NEG output.
Also on H/3 10 pin heavy gauge, only use the PINK.
In fact you can save the connecter and use a thinner gauge cable with a faston or soldered to that pin, the way you're using it it's only an ignition sense wire.
Except; if you want starter cut use the green and the violet as per instructions on the starter wire.
------------- Test before boxing up.
Posted By: hoe_nah808
Date Posted: February 24, 2014 at 5:41 PM
okay got almost everything wired up. for the most part everything is working properly except when I set off my alarm to check the sensitivity. when I disarm the alarm system the led amd remote lets me know the alarm was tripped. how do I clear this? the led continues to flash and let me know it was tripped. my previous alarm systems when I turned the igniton to on it would clear it. which wire does this?
Posted By: hoe_nah808
Date Posted: February 24, 2014 at 5:52 PM
ahhhhh I think that heavy gauge pink wire is for that ^^^^^
|