2012 Camaro with Boston Acoustics System
Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=139172
Printed Date: April 28, 2024 at 3:15 AM
Topic: 2012 Camaro with Boston Acoustics System
Posted By: justanotherday
Subject: 2012 Camaro with Boston Acoustics System
Date Posted: July 08, 2015 at 7:01 AM
I'm looking for info on where to pull speaker level input from the rear of the vehicle for a bazooka tube. The info out there is close, but there's virtually no bass coming from where I tapped each rear deck speaker. I found some info that said to pull blue+ and blue w/black tracer - on the right, and green+ and blue w/black tracer- on the left. There's just no bass in it, lots of mention about the amplifier in the rear wall, but nothing specific or concrete.
Thanks in advance for any help.
Replies:
Posted By: i am an idiot
Date Posted: July 08, 2015 at 3:04 PM
You have to get signal from the factory subwoofer which is mounted in the middle of the rear seat seatback.
Posted By: sparkie
Date Posted: July 08, 2015 at 5:27 PM
Each rear speaker is dual voice coil. One voice coil is full range and the other is subwoofer. The subwoofer circuits are:
Dark green (+) and light blue/black (-) for right rear.
Dark blue/white (+) and light GREEN/ black (-) left rear.
Wires can also be connected to at the 8 pin Gray connector at the amplifier. The White wire in the amp's 16 in black plug is the amp turn on trigger.
-------------
sparky
Posted By: justanotherday
Date Posted: July 09, 2015 at 8:24 PM
Thanks guys. The non-convertible didn't have a sub in the back wall, tapping the wires per Sparky did the trick.
Much appreciated.
J.
|