Print Page | Close Window

2004 Ford Explorer Remote Start Wiring

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=21965
Printed Date: May 02, 2024 at 12:07 AM


Topic: 2004 Ford Explorer Remote Start Wiring

Posted By: Falcon 1
Subject: 2004 Ford Explorer Remote Start Wiring
Date Posted: November 25, 2003 at 8:22 PM

Hi I am looking for the wiring info to do a remote start in a 2004 Ford Explorer.

Thanks.



-------------
Do it right the first time, only a doctor can bury his mistakes.



Replies:

Posted By: Montrealler
Date Posted: November 26, 2003 at 8:07 AM
this is for the 2003 explorer sport

Check the section you want to print Print the Infotech    

ITEM WIRE COLOR POL LOCATION INFOTECH # PHOTO NOTE

12 VOLTS   yellow + ignition harness    
STARTER 1   RED / lt. blue + ignition harness    
STARTER 2   n/a      
IGNITION 1   lt. GREEN/ purple + ignition harness    
IGNITION 2   n/a      
IGNITION 3   n/a      
ACCESSORY 1   brown (x2) + ignition harness    
ACCESSORY 2   BLACK/ green + ignition harness    

POWER LOCK   pink / YELLOW    driver kick panel   On models with keyless entry the door locks are negative trigger. Without keyless entry they are 5wi reverse polarity.
POWER UNLOCK   pink/lt. green    driver kick panel   On models with keyless entry the door locks are negative trigger. Without keyless entry they are 5wi reverse polarity.
DISARM NO UNLOCK   see factory alarm disarm      
FACTORY ALARM ARM   arms on lock      Arms on lock only with door open. It is necessary to send a signal to door trigger as well as lock to arm factory alarm.
FACTORY ALARM DISARM   dk. GREEN/ purple - driver kick panel    
DOORLOCK MOTOR   pink/black 5wi driver kick panel    
DOOR UNLOCK MOTOR   RED / orange 5wi driver kick panel    

PARKLIGHTS POSITIVE   WHITE/ black or brown + headlight switch or dkp    
PARKLIGHTS NEGATIVE   WHITE/ purple - csm behind glove box    
REVERSE   BLACK/ pink + driver kick panel    
BRAKE   lt. green + brake pedal switch    

DOOR PIN   yellow/black (l), gray/red (r)   - each door harness   Use both wires and diode isolate each from the GEM module, refer to DirectFax document 1076 for wiring information.
HOOD PIN   tan/lt. green - driver kick panel    
TRUNK PIN   WHITE/ purple - driver kick panel    
DOMELIGHT SUPERVISION   use door trigger      

TACH   tan / YELLOW   ac pcm   The PCM (Powertrain Control Module) is located at the top of the firewall towards the passenger side. The tan / YELLOW tach wire is also found at the back of the instrument cluster. Can also use any tan/stripe wire at the coil pack.

TRUNK RELEASE   n/a      
SLIDEDOORS   n/a      

HORN   yellow/lt. green - steering column   




Posted By: Falcon 1
Date Posted: November 26, 2003 at 3:28 PM
Thanks very much for the information Montrealler.

-------------
Do it right the first time, only a doctor can bury his mistakes.


Print Page | Close Window