I am hooking up a car starter on this Concorde and would like info on the colour of wires I need to hook it up. I think all I need is the colour of a wire that has power in the start and crank positions. thanks
| CHRYSLER CONCORDE 93-95 |
| WIRE | COLORS | LOCATION |
| 12 VOLTS CONSTANT | PNK/BLK & RED | IGN HARNESS |
| IGNITION 1 | D BLU | IGN HARNESS |
| IGNITION 2 | RED / WHT | IGN HARNESS |
| IGNITION 3 |
| ACCESSORY /HEATER BLOWER 1 | BLK/ORG | IGN HARNESS |
| ACCESSORY /HEATER BLOWER 2 |
| STARTER | YEL | IGN HARNESS |
| PARKING LIGHTS | BLK/YEL(+) | HEADLIGHT SWITCH |
| DOMELIGHT | YEL(-) | 12 PIN CONN IN DRV KICK |
| PWR DOOR LOCK | ORG/WHT | 12 PIN L BLU CONN |
| PWR DOOR UNLOCK | PNK/VIO | ON BACK OF FUSE BLOCK (TYPE A) |
| TRUNK RELEASE | BLK/WHT(+) | AT RELEASE SWITCH |
| TACH SENSOR | GRY, RED / YEL | @ COIL PACK ON ENG |
BRAKE | WHT/TAN(+) | AT SWITCH ON BRAKE PEDAL BRACKET |
HORN | BLK/RED(-) | STEER COLM |
FACTORY DISARM | L GRN/ORG(-) | BLK 16 PIN CONN IN DRV KICK PANEL |
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
Very awesome!, thanks a lot. But I just got in from the garage! I'll work on it tomorrow maybe. thanks again.
Question though...when you say "GRY, RED / YEL" for the tach sensor...that means 2 wires? thanks
use only one use the gray one
TACHOMETER|gray | |ignition coil pack
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.
Hey Bnluis...how about the wires i need for a '95 Jeep Cherokee? and what do i have to do to wire the door locks into the auto starter (it has that option). I do have the factory keyless entry remote.
I don't recommend using the factory remote, On those year models the distance sucks, but if you starter comes with remotes that operate door locks you can always connect them. Some of those car are equipped with factory alarms, you will require some relays.
Jeep | Grand Cherokee | 1993-1995 |
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | YELLOW/DARK BLUE | IGNITION SWITCH HARNESS |
Ignition #1: | | DARK BLUE/GRAY | IGNITION SWITCH HARNESS |
Ignition #2: | | ORANGE / BLACK | IGNITION SWITCH HARNESS (HEAT-A/C) |
Ignition #3: | | N/A | |
Accessory: | | BLACK/ WHITE | IGNIITON SWITCH HARNESS (RADIO/WIPER) |
Brake Light: | | WHITE/ TAN (+) | SWITCH ON BRAKE PEDAL BRACKET |
Tach Signal: | | GRAY/WHT OR GRAY/BLACK | AT COIL OR PCM * |
Parking Lights: | | DARK BLUE/RED (+) | HEADLIGHT SWITCH OR AT FUSE BOX |
Headlights: | | TAN/BLACK (+) | HEADLIGHT SWITCH OR BEAM SELECT SW. |
OEM Alarm Disarm: | | VIOLET / YELLOW | (-) DRIVER KICK PANEL |
OEM Alarm Arm: | | N/A | |
Diesel Glow Plug: | | | |
Clutch Bypass Wire: | | | |
Notes: | | * Powertrain Control Module (PCM) Located In Passenger Rear Corner Of Engine Compartment Near A/C Receiver/Dryer. Tach Wire At Pin #19, GRAY/L BLUE At Pin #43 Can Also Be Used For Tach. |
Jeep | Grand Cherokee | 1993-1995 |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | RED / WHITE FUSED AT # | AMP AND PINK/BLACK FUSED AT # AMP |
Starter Kill: | | YELLOW/DARK BLUE | IGNITION SWITCH HARNESS |
Ignition +12 Volts: | | DARK BLUE/GRAY | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | YELLOW (-) | DRIVER KICK PANEL OR COURTESY LIGHT |
OEM Horn: | | GRAY/ORANGE (-) | STEERING COLUMN HARNESS OR AT RELAY |
Power Lock: | | ORANGE / VIOLET | DRIVER'S KICK PANEL ** |
Power Unlock: | | PINK/VIOLET | DRIVER'S KICK PANEL ** |
Trunk Release: | | ORANGE / BROWN (+) | LIFT GLASS RELEASE (AT SWITCH) |
Alarm Input Wire: | | YELLOW (-) | DRIVER KICK PANEL OR COURTESY LIGHT |
Notes: | | ** See Note #202 - Positive Pulse Door Lock Diagram. |
-------------
Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible.