I need to find out if I have a positive door trigger or a neagative and where I could find it and what color. Also, where are the constant 12v and accessory wires? Thanks.
hope this helps...........
| 12volts | yellow, grn/purple | + | ignition harness | | Starter | RED / lt. blue | + | ignition harness | | Second Starter | | | | | Ignition | blue/lt. green | + | ignition harness | | Second Ignition | gray / YELLOW(2nd acc) | + | ignition harness | | Third Ignition | | | | | Accessory | RED / black | + | ignition harness | | Second Accessory | BLACK/ green | + | ignition harness | | Keysense | | | | | Power Lock | pink / YELLOW | - | keyless module | | Notes: The keyless module is located high in the drivers kick against the firewall. | | Power Unlock | pink/green | - | keyless module | Notes: The GEM in this vehicle shuts down after the doors have been locked for a certain time period, to wake-up the system refer to directfax document #1093.
The keyless module is located high in the drivers kick against the firewall. | | Lock Motor | pink/black | | drivers kick panel | | Unlock Motor | RED / orange | | drivers kick panel | | Parking Lights+ | brown | | at light switch | | Parking Lights- | | | | | Hazards | | | | | Turn Signal(L) | | | | | Turn Signal(R) | | | | | Reverse Light | | | | | Door Trigger | lt. blue/white | - | keyless module | Notes: One of two. The wire is in pin 11 and it is next to the BLACK/ pink wire. Test with a digital multi-meter ONLY, to keep from damaging the circuit tied into the other lt. blue/white. For individual door trigger wires, the LF door is BLACK / YELLOW, the RF door is BLACK/ pink, the LR door is BLACK/ lt. blue, and the RR door is BLACK/ white. They are all negative and are at the GEM module, which is attached to the fuse box.
The keyless module is located high in the drivers kick against the firewall. | | Dome Supervision | BLACK/ lt. blue | + | passenger kick panel | | Trunk/Hatch Pin | tied in with door | | | | Hood Pin | | | | | Trunk/Hatch Release | | | | | Power Sliding Door | | | | | Factory Alarm Arm | N/A | | | | Factory Alarm Disarm | N/A | | | | Disarm No Unlock | N/A | | | | Tachometer | | | | | Notes: Tach wire: On the 4.6L go to any of the 8 ignition coils and use the wire that is not RED / green. On the 5.4L it is a lt. GREEN / WHITE at the coil on the passenger side of the motor between the fuel injectors. | | Wait to start | | | | | Brake Wire | green | + | at brake switch | | Parking Brake | | | | | Horn Trigger | dk. blue | - | steering column | | Memory Seat 1 | | | | | Memory Seat 2 | | | | | Memory Seat 3 | | | |
 | Immobilizer Bypass Module: | Required: Yes | Type: PATS | Part #: 555P, 555F, or 555U | | Notes: N/A |
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. |
|
Is the Diagram for 2000 Expedition as well ?
And how EZ is it to instcar all on the?
So are you sure that I have a negative door trigger and that the LF door is BLACK / YELLOW? I always thought they were positive.
BTW: I greatly appreciate your help.