I am searching for a tech sheet for a 04 BMW Roadster. I need +12v, ignition, starter, horn, and unlock colors/locations. I am going to be installing a gps tracking unit from microtrakgps. thanks in advance. Kelly
-------------
10 years and counting....
I can only find the 2002 Z3:
BMW | M/Z3 Roadster | 1996-2002 |
Remote Starter Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Start: | | BLK/YEL OR BLK/GRN | IGNITION SWITCH HARNESS * |
Ignition #1: | | GREEN | IGNITION SWITCH HARNESS |
Ignition #2: | | GREEN / WHITE | IGNITION SWITCH HARNESS |
Ignition #3: | | N/A | |
Accessory: | | VIOLET | IGNITION SWITCH HARNESS |
Brake Light: | | RED / BLUE | AT SWITCH ABOVE BRAKE PEDAL *** |
Tach Signal: | | BLACK | BEHIND INSTRUMENT CLUSTER ** |
Parking Lights: | | GRAY/VIOLET (DS) & | GRAY / YELLOW (PS) AT HEADLIGHT SW, ***** |
Headlights: | | YELLOW (+) | AT HEADLIGHT SWITCH |
OEM Alarm Disarm: | | | |
OEM Alarm Arm: | | | |
Diesel Glow Plug: | | | |
Clutch Bypass Wire: | | | |
Notes: | | * This Vehicle Is Equipped With A Transponder Type Theft System. See Installation Note #144 - Bypassing Transponder Theft Systems. ** Wire Can Be Found Near Light Switch, Instrument Cluster Or At Diagnostic Plug Near Passenger Rear Of Engine Compartment. *** This Wire Will Only Test With The Ignition On. |
BMW | M/Z3 Roadster | 1996-2002 |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | | Vehicle Color | Location |
Constant +12 Volts: | | RED / YELLOW | # PIN CONNECTOR BEHIND GLOVE BOX |
Starter Kill: | | BLK/YEL OR BLK/GRN | IGNITION SWITCH HARNESS * |
Ignition +12 Volts: | | GREEN | IGNITION SWITCH HARNESS |
Dome Lights/Superv: | | BRN/WHT/YEL (DS) & | BRN/BLU (PS) (-) BEHIND GLOVE BOX **** |
OEM Horn: | | VIOLET/BLUE (+) | AT HORN |
Power Lock: | | WHITE/ RED / YELLOW (+) | AT ALARM PLUG BEHIND GLOVE BOX ****** |
Power Unlock: | | BLUE/RED / YELLOW (+) | AT ALARM PLUG BEHIND GLOVE BOX ****** |
Trunk Release: | | BROWN / WHITE (-) | AT ALARM PLUG BEHIND GLOVE BOX ******* |
Alarm Input Wire: | | BRN/WHT/YEL (DS) & | BRN/BLU (PS) (-) BEHIND GLOVE BOX **** |
Notes: | | **** Must Diode Isolate Each Side, Cathode (Band) Faces Pin Switches. ***** Split Parking Light System - must use relays to isolate the circuits from each other., Connect Both Wires. ****** See Installation Note #202 - Positive Trigger Door Lock Diagram. ******* See Installation Note #232 - Negative Trunk Release Diagram. |
DesignTech International, Inc. | Tel: (703) 866-2000 Fax: (703) 866-2001 | ©2002 All Rights Reserved |
7955 Cameron Brown Court
Springfield, Virginia 22153 USA | 1-800-DESIGNTECH
(1-800-337-4468) | DesignTech International, Inc.
www.designtech-intl.com |
DesignTech disclaims any liability or responsibility arising out of any inaccuracies of this information or use of this
information for installations or otherwise. Please verify all wiring for accuracy prior to making any connections. |
-------------