Im trying to find a wiring diagram for a 94 ford explorer..... I looked on this site, but its either wrong, or just confusing.......I only see half of the colors the site says there are, and some of them, it asks for twice..... HELP!!!
try this ::::
Remote Starter Wiring Colors and Notes |
Function | | DTI Color | Vehicle Color | Location |
Start: | | Yellow | RED / LIGHT BLUE | IGNITION SWITCH HARNESS |
Ignition #1: | | Blue | RED / LIGHT GREEN | IGNITION SWITCH HARNESS |
Ignition #2: | | Green | GRAY / YELLOW (16 AWG) | IGNITION SWITCH HARNESS ** |
Ignition #3: | | Wht/Blk | GRAY / YELLOW-2WIRES | IGNITION SWITCH HARNESS ** |
Accessory: | | White | BLACK/ GREEN | IGNITION SWITCH HARNESS |
Brake Light: | | Orange | GREEN (+) | AT SWITCH ON BRAKE PEDAL BRACKET |
Tach Signal: | | Green | TAN / YELLOW | AT COIL (3.0L) * |
Parking Lights: | | Yellow | BROWN | (+) AT LIGHT SWITCH |
Headlights: | | Yellow | RED / YELLOW (+) | HEADLIGHT SWITCH OR BEAM SELECT SW. |
OEM Alarm Disarm: | | Brn/Wht | N/A | |
OEM Alarm Arm: | | n/a | N/A | |
Diesel Glow Plug: | | RED / Black | | |
Clutch Bypass Wire: | | n/a | | |
Notes: | | * 2.3L Tach Wire Is BLACK / YELLOW At EDIS Module. On All Explorers Except 3.0L Tach Test Connector Can Be Found On Passenger Rear Corner Of Engine Compartment Near The Blower Motor. ** See Note #211 - Ford Ignition Switch Connection Diagram. Alarm and Keyless Entry Wiring Colors and Notes | Function | | DTI Color | Vehicle Color | Location | Constant +12 Volts: | | Red | 2 YELLOW OR 2 GREEN | IGNITION SWITCH HARNESS | Starter Kill: | | Vlt or Wht | RED / LIGHT BLUE | IGNITION SWITCH HARNESS | Ignition +12 Volts: | | Orange | RED / LIGHT GREEN | IGNITION SWITCH HARNESS | Dome Lights/Superv: | | Brown | BLACK/ LIGHT BLUE | (+) AT PIN SWITCH | OEM Horn: | | Blue | DARK BLUE (+) OR | YELLOW/LIGHT GREEN (-) IN COLUMN | Power Lock: | | Wht/Red | PINK / YELLOW | DRIVER'S KICK PANEL *** | Power Unlock: | | Yel/Red | PINK/LIGHT GREEN | DRIVER'S KICK PANEL *** | Trunk Release: | | Grn/Wht | N/A | | Alarm Input Wire: | | R/W or Gy/Bk | BLACK/ LIGHT BLUE | (+) AT PIN SWITCH | Notes: | | *** Without OEM Keyless Entry See Note #203 - Reverse Polarity Door Lock Diagram, With OEM Keyless See Note #202 - Positive Pulse Door Lock Diagram. |
try this all you need from this is the vehicle wire chart. |
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
I need help i had a short in my 98 explorer and smoked quite a bit of wires, but there is a block that goes to the rear radio and blower does anybody know where i could get a diagram for that.
-------------
ron30