12volts | WHITE/ red (30A), white (5A) | + | ignition harness |
Starter | BLACK/ white | + | ignition harness |
Second Starter | BLACK / YELLOW | + | ignition harness |
Ignition | BLACK/ red | + | ignition harness |
Second Ignition | BLACK / YELLOW | + | ignition harness |
Third Ignition | N/A | | |
Accessory | blue/red | + | ignition harness |
Second Accessory | N/A | | |
Keysense | blue | - | ign harn or BECU, top plug, pin 19 |
Notes: Using the status output to trigger this wire during remote start will disarm the alarm without unlocking the doors.
The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge.
|
Power Lock | blue / YELLOW | - | DKP or bottom of fusebox, 20 pin plg |
Notes: Meter this wire while turning the key in the driver door key cylinder. |
Power Unlock | blue (double pulse) | - | DKP or BECU, top plug, pin 22 |
Notes: Meter this wire while turning the key in the driver door key cylinder.
The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge.
Can also use the passenger door key cylinder unlock wire, which only requires a single pulse. It is blue/white (-) in the BECU, top plug, pin 21. |
Lock Motor | blue/red | 5wi | DKP or bottom of fusebox, 13 pin plg |
Unlock Motor | blue/black | 5wi | DKP or BECU, bottom plug, pin 11 |
Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. |
Parking Lights+ | green | + | DKP or bottom of fusebox, 20 pin plg |
Parking Lights- | red | - | switch or BECU, top plug, pin 8 |
Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. |
Hazards | lt. GREEN/ black | - | switch or BECU, middle plug, pin 10 |
Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. |
Turn Signal(L) | GREEN / WHITE | + | turn signal flasher relay in DKP |
Turn Signal(R) | GREEN/ YELLOW | + | turn signal flasher relay in DKP |
Reverse Light | RED / black | + | DKP or bottom of fusebox, 20 pin plg |
Door Trigger | see notes | - | see notes |
Notes: The LF door is RED / green in the BECU, bottom plug, pin 1. The RF door is RED / green in the BECU, top plug, pin 11. The rear doors are RED / white in the bottom of the fuse box, 20 pin plug, pin 7. Use all three wires and diode isolate each.
The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. |
Dome Supervision | GREEN/ red | - | ignition key cylinder light |
Trunk/Hatch Pin | green | - | DKP or BECU, bottom plug, pin 6 |
Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. |
Hood Pin | black | - | theft deterrent ECU behind glovebox |
Trunk/Hatch Release | WHITE/ blue | 5wi | DKP or BECU, bottom plug, pin 12 |
Notes: The Body ECU is attached to the back of the fuse box under the driver side dash. The plugs for the BECU are on the left side edge. |
Power Sliding Door | N/A | | |
Factory Alarm Arm | arms with lock | | |
Factory Alarm Disarm | disarms with unlock | | |
Disarm No Unlock | use key sense wire | | |
Tachometer | BLACK/ orange | ac | ECM behind glovebox |
Notes: On the 4 cylinder models, it is in the 2nd plug from the top, pin 1. On the 6 cylinder models, it is in the top plug, pin 5.
Can also go to any ignition coil or fuel injector and use the wire that is NOT BLACK/ red, WHITE/ red, or WHITE/ black. |
Wait to start | N/A | | |
Brake Wire | GREEN / WHITE | + | sw or bottom of fusebox, 20 pin plug |
Parking Brake | RED / white | - | parking brake switch |
Horn Trigger | GREEN/ black | - | sw or bottom of fusebox, 24 pin plug |
Memory Seat 1 | N/A | | |
Memory Seat 2 | N/A | | |
Memory Seat 3 | N/A | | |