I used to work for Alte Mere tinting, alarm, and audio..........I just tinted and installed car audio systems but never really messed with remote start and alarms. Now I want to install alarms and remote start. I dont know where to learn. I live in salt lake city, Utah.
My main problem right now is how to install a Sting alarm, keyless, and remote start system. Can you tell me what procedures i need to take? I take the door panels off right? I think it has keyless and alarm already but I dont have the remote, not sure though. Ive found most of the wires I just need to know if there is anything else I need to do........I have a 2000 Acura TL 3.2 ....
please reply....ill take any advice
-------------
michael conell
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|white |+ |ignition harness |
| STARTER|BLACK/ white |+ |ignition harness |
| IGNITION|BLACK / YELLOW |+ |ignition harness |
| ACCESSORY|yellow |+ |ignition harness |
| POWER LOCK|BLACK/ blue |- |passenger fuse box *1 |
| POWER UNLOCK|orange |- |passenger fuse box *1 |
| LOCK MOTOR|WHITE/ red | |drivers fuse box *2 |
| UNLOCK MOTOR|yellow | |drivers fuse box *2 |
| DISARM DEFEAT|lt. GREEN/ red | |passenger MUX module *3 |
| PARKING LIGHTS +|RED / black | |passenger kick panel |
| PARKING LIGHTS -|RED / yellow | |left of steering column |
| HEADLIGHTS|blue/red |- |left of steering column |
| DOOR TRIGGER|BLACK/ white |- |passenger fuse box |
| DOME SUPERVISION|use door trigger | | |
| TRUNK/HATCH PIN|blue/green |- |drivers fuse box |
| HOOD PIN|yellow |- |passenger fuse box |
|TRNK/HTCH RELEASE|WHITE/ red |+ |passenger MUX module *3 |
| FCTRY ALARM ARM|arms with lock | | |
|FCTRY ALRM DISARM|disarms with unlock | | |
| DISARM NO UNLOCK|blue |- |drivers door key cylinder |
| TACHOMETER|blue | |drivers shock tower *4 |
| SPEED SENSE| | | |
| BRAKE WIRE|WHITE/ black |+ |brake switch |
| HORN TRIGGER|lt. GREEN/ blue |- |steering column |
| WIPERS|blue & blue / YELLOW |- |left of steering column |
| LF WINDOW UP/DN|RED / yel - RED / blu |A |drivers window motor |
| RF WINDOW UP/DN|blu/wht - blu/yel |A |RF window switch |
| LR WINDOW UP/DN|RED / blu - RED / yel |A |LR window switch |
| RR WINDOW UP/DN|RED / blk - RED / yel |A |RR window switch |
| SUN RF OPN/CLOSE|grn/yel - grn/red |A |relays left of fuse box |
| RADIO 12V|WHITE/ green |+ |radio |
| RADIO GROUND|black |- |radio |
| RADIO SWITCH|WHITE/ red |+ |radio |
| RADIO ILLUMINATE|RED / black |+ |radio |
| POWER ANTENNA| | | |
| LF SPEAKER|blu/grn - gry/blk | |radio |
| RF SPEAKER|RED / grn - brn/blk | |radio |
| LR SPEAKER|blu/yel - gry/wht | |radio |
| RR SPEAKER|RED / yel - brn/wht | |radio |
Notes:Here are some notes about the vehicle that you will need to know before you begin the installation:
NOTE: This vehicle has an immobilizer system that needs to be bypassed when adding remote start. https://www.velocitymotorsport.com/security/honda_transponder.htm *1 Located in a green 20-pin connector. Use the key switch in the passenger door to test. *2 Located in a green 18-pin connector. *3 The passengers MUX module is located behind the glove box. *4 In a 2-pin connector near the air intake on the drivers side shock tower.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
no you dont need to take the door pannels off for anything you will most likely find everything you need like parking lights brake shutdown , door triggers etc in driver door kick pannel ,. the tack wire needs to be ran into the engine compartment and connected to above stated wire .
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
thanks that helps me a lot.......it sucks that i have to buy that though
-------------
michael conell