05 Dodge Neon Alarm/Start Wiring

Can someone please help me with the wiring information for an 05 Dodge Neon. I would like to do a remote start alarm.

Thanks

-------------
Fred Kincaid
Visions Sound & Security
GPS Northwest

DIRECTWIRE™ WIRING INFORMATION - DODGE / NEON / 2005 / Remote Start


12volts pink/black (40A), red (30A)   +   ignition harness
Starter yellow   +   ignition harness
Second Starter N/A       
Ignition dk. blue   +   ignition harness
Second Ignition RED / wht (with Autostick only)   +   ignition harness
Third Ignition N/A       
Accessory BLACK/ orange   +   ignition harness
Second Accessory BLACK/ white   +   ignition harness
Keysense lt. blue   -   ignition harness
Power Lock lt. green   -   driver kick, door harness
Notes: Lock is negative trigger thru a 1K (1000) ohm resistor. Unlock is negative trigger thru a 250 ohm resistor. MUST use relays.

If the vehicle has factory alarm, arm/lock is negative trigger thru a 2.7K (2700) ohm resistor, and disarm/unlock is negative trigger thru a 7.5K (7500) ohm resistor, use double pulse for unlock.

Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.

Can also use Directed 457C or 456L interface modules.
Power Unlock same as power lock wire       
Lock Motor ORANGE / black   5wi driver kick, door harness
Notes: Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Unlock Motor pink/black   5wi driver kick, door harness
Notes: Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Parking Lights+ BLACK / YELLOW   +   headlight switch
Notes: Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Parking Lights- N/A       
Hazards same as turn signal wires       
Turn Signal(L) lt. green (F), dk. grn/red (R) +   turn signal switch
Turn Signal(R) tan (F), BROWN / red (R)   +   turn signal switch
Reverse Light PURPLE / black   +   driver kick, harness to rear
Door Trigger tan/blk (D), lt. blue/org (P)   -   dr kick, door harn and harn to rear
Notes: Use both wires and diode isolate each.

Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Dome Supervision yellow   -   driver kick, harness to rear
Trunk/Hatch Pin tan/black   -   trunk pin switch or light in trunk
Hood Pin BROWN / tan (export model only)   -   hood pin switch under hood
Notes: Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Trunk/Hatch Release BROWN / lt. blue   -   release switch in glovebox
Notes: Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Power Sliding Door N/A       
Factory Alarm Arm arms with lock       
Factory Alarm Disarm disarms with unlock       
Disarm No Unlock with ignition and Sentry Key       
Tachometer NOT dk. GREEN/ orange   ac   ignition coil or any fuel injector
Wait to start N/A       
Brake Wire WHITE/ tan   +   brake pedal switch
Parking Brake WHITE/ black   -   parking brake switch
Horn Trigger BLACK/ red   -   horn switch
Notes: Also found at the Remote Keyless Entry Module in the top center of the dash. Remove the dash top to access.
Memory Seat 1 N/A       
Memory Seat 2 N/A       
Memory Seat 3 N/A       
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Sentry Key
Part #: 555CW
Alternate Part1 #: 556UW
Alternate Part2 #: 555U
Notes: Only vehicles with gray keys have the immobilizer.
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Data Bus
Part #: 457CW
Alternate Part1 #: 456LW
Notes:



      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.





-------------
Be careful whose advice you buy, but be patient with those who supply it.