i am about to install a alarm in my dodge but its been awhile since i have done an alarm. it has the crappy factory security system that locks the doors and the horn honks if the doors are opened from the inside. my question is how do i disarm that crap so i can install the real alarm. or do i even need to. someone let me know. thanks
Well here is the sheet for your vehicle. It has the OEM alarm disarm wire.
Dodge |
| Dakota |
| 1997 - 1999 |
|
Remote Starter Wiring Colors and Notes |
Function | Vehicle Color | Location |
Start: | DK. BLUE / YELLOW | |
Ignition #1: | D BLUE | IGNITION SWITCH HARNESS |
Ignition #2: | BLACK/ ORANGE | IGNITION SWITCH HARNESS (BLOWER) |
Ignition #3: | N/A | |
Accessory: | BLACK/ WHITE | IGNITION SWITCH HARNESS |
Brake Light: | WHITE/ TAN (+) | AT SWITCH ABOVE BRAKE PEDAL |
Tach Signal: | BLACK/ GRAY | AT IGNITION COIL OR PCM * |
Parking Lights: | BLACK / YELLOW (+) | AT HEADLIGHT SWITCH ** |
Headlights: | L GREEN (+) | AT HEADLIGHT SWITCH (# - # ONLY) |
Diesel Glow Plug: | | |
Clutch Bypass Wire: | | |
Notes: | * Powertrain Control Module (PCM) Located On Passenger Rear Of Engine. |
Alarm and Keyless Entry Wiring Colors and Notes |
Function | Vehicle Color | Location |
Constant +12 Volts: | PINK/BLACK & RED | IGNITION SWITCH HARNESS |
OEM Alarm Disarm: | BLACK/ ORANGE (-) | # PIN BLACK CONN. BEHIND DR. DASH |
OEM Horn: | BLACK/ RED (-) | STEERING COLUMN HARNESS |
Power Lock: | ORANGE / VIOLET | # PIN BLACK CONNECTOR BELOW |
Power Unlock: | PINK/VIOLET | FUSE BOX BEHIND DRIVER DASH *** |
Trunk Release: | N/A | |
Alarm Input Wire: | YELLOW (-) | AT COURTESY LIGHT OR HEADLIGHT SWITCH |
Notes: | ** BLACK / YELLOW (+) Wire Also Found In 74 Pin Connector Below Fuse Box Behind Driver Dash. *** See Note # 202 - Positive Pulse Door Lock Diagram For 1997 - 1998 Models, And Note # 203 - Reverse Polarity Door Lock Diagram For 1999 - 2000 Models. |