2006 Rav4 Limited V6 Alarm/Remote Start Wiring

does anyone have a wiring colour code for a 2006 Rav 4 Limited V6

remote start install with factory security bypass

Thanks

Jason

Toyota 2006 RAV4 4DR SUV

(Remote Start / Security / GPS)

Wire/Function	Colour	Location/Description	Polarity
PASSIVE ANTI-THEFT	YES	TRANSPONDER	SEE NOTES
12 VOLTS	Blue	Ignition switch harness	+
IGNITION	White	Ignition switch harness	+
There are 2 wires of this color at the switch, test carefully.
IGNITION 2	Pink	Ignition switch harness	+
ACCESSORY	Red	Ignition switch harness	+
STARTER	White	Ignition switch harness	+
STARTER 2	Yellow	Ignition switch harness	+
There are 2 wires of this color at the switch, test carefully.
KEY SENSE	Blue	Ignition switch harness	-
TACH SIGNAL	Gray	Diagnostic plug below dash on driver's side	AC
LOCK	Pink	On white plug in driver's kickpanel	-
UNLOCK	Black (double pulse)	On white plug in driver's kickpanel	-
DOORPIN	White	6-pin plug on fusebox	-
TRUNK PIN	Lt.green	On 30-pin plug on top of fusebox	-
FACTORY ARM	Arms with lock
FACTORY DISARM	Disarms with unlock
BRAKESWITCH	Blue	At switch or 30-pin plug on top of fusebox	+
PARKLIGHTS	Green	On 30-pin plug on top of fusebox	+
HAND BRAKE	Black	On 14-pin plug on top of fusebox	-
HORN	Lt.green	At steering column	-
HEADLIGHTS	Blue	At light switch harness	-
REVERSE LIGHTS	Red	On 30-pin plug on top of fusebox	+
VSS WIRE	Violet	On back of radio	AC

Vehicle Notes	PLEASE NOTE: This vehicle is equipped with TRANSPONDER chips in the ignition keys. This system must be bypassed for Remote Starter installation. A keyless bypass module may be available, contact your distributor to find out. If one of these modules is not available to you, see the appropriate security diagram for bypass instructions.
Additional Notes	WHEN PROGRAMMING THE PATS TOYOTA THE BLACK WIRE FROM PATS TOYOTA MODULE TO GROUND FIRST. AFTER THE BLACK WIRE IS GROUNDED GROUND THE BLUE KEY SENSE WIRE ON THE IGNITION BARREL. DO NOT GROUND AT THE SAME TIME.

-------------

thanks for posting this key information

I just finished installing my alarm on a 2006 rav4 limited. It works perfect most of the signals, however "Doorpin" signal was not found based on this list. It was not possible for me to find it, but I found the "Front Driver door pin signal" on the 30 connecter on top of fusebox white cable negative signal.

For opening the doors there is also some differences from this post:
Open driver door: pink cable On white plug in driver's kickpanel -
Open all doors: black cable on white plug in driver's kick panel -
Close all doors: Another pink cable on white plug in driver's kick panel -

If some ones found the All doors pin signal, please send me and advice so I can check all the doors and not only driver door like I has it right now.

Does anyone have the color codes and places for signal lights? I am trying to hook up trailer lights.

Does anyone have color codes and locations for signal lights. I am trying to hook up a trailer light package. Thanks