2003 Nissan Sentra, Remote Start Wiring

Looking for the specs to install a remote start on an 03 Nissan Sentra. 

PART	COLOR	LOCATION
12 VOLT CONSTANT	WHITE/ RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/ WHITE (+) See NOTE *1	IGNITION SWITCH HARNESS
STARTER 2	BLACK / YELLOW (+) See NOTE *1	IGNITION SWITCH HARNESS
IGNITION 1	BLACK/ RED (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY /HEATER BLOWER 1	WHITE (+)	IGNITION SWITCH HARNESS
ACCESSORY /HEATER BLOWER 2	WHITE/ BLUE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	WHITE/ RED (+) or RED / BLUE (+)	IN DRIVERS KICK PANEL or HEADLIGHT SWITCH
POWER LOCK	GRAY (TYPE B)	@ SECU, See NOTE *2
POWER UNLOCK	PURPLE / RED (TYPE B)	@ SECU, See NOTE *2
DOOR TRIGGER	See NOTE *3	@ SECU, See NOTE *2
DOMELIGHT SUPERVISION	RED / YELLOW (-)	@ SECU, PIN 8, See NOTE *2
TRUNK RELEASE	RED (-)	@ HATCH RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	WHITE/ GREEN (-)	@ STEERING COLUMN HARNESS
TACH	ANY WIRE BLACK/ RED, PURPLE, BLUE/RED or GRAY/RED	@ ANY IGNITION COIL
WAIT TO START LIGHT	N/A
BRAKE	RED / GREEN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	WHITE/ BLUE(-)	@ SECU, PIN 30, See NOTE *2
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

EXTRA INFORMATION

NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold. NOTE *2 THE SECU (Security Electronic Control Unit) IS LOCATED TO THE RIGHT OF STEERING COLUMN. NOTE *3 ON VEHICLES WITHOUT POWER DOORLOCKS USE RED / WHITE (-) IN DRIVERS KICK PANEL. ON VEHICLES WITH POWER DOORLOCKS, USE RED (-) FOR DRIVERS DOOR AND RED / WHITE (-) FOR PASSENGER DOOR, WHEN CONNECTING TO AN ALARM SYSTEM USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM

-------------