Print Page | Close Window

2006 Dodge Ram Alarm/Remote Start/Stereo Wiring

Printed From: the12volt.com
Forum Name: Vehicle Wiring Information & File Requests
Forum Discription: Request Car Alarm, Car Stereo, Cruise Control, Remote Starter, Navigation, Mobile Video, and Other Vehicle Specific Wiring Info, Manuals, Tech Tips
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=91360
Printed Date: March 28, 2024 at 9:12 AM


Topic: 2006 Dodge Ram Alarm/Remote Start/Stereo Wiring

Posted By: m1e1w1
Subject: 2006 Dodge Ram Alarm/Remote Start/Stereo Wiring
Date Posted: March 07, 2007 at 7:05 AM

Im looking for a complete book, for wiring on a 2006 dodge ram 1500 quad cab ST. 4 door 4x4.

im looking to install an after market radio, alarm, remote start, keyless entry and a kit to convert my maual door lock's to automatic with an actuator install kit.

i dont have the maual for the alarm kit, i lost the instructions. and cant contact the company who makes the unit.

ive got all the instuctions for everything else, but was looking for a wiring diagram for this truck. anywhere i can find something like this? online?




Replies:

Posted By: warpedimage3
Date Posted: March 07, 2007 at 9:04 AM
DODGE / RAM PICKUP / 2006 / Remote Start


12volts               lt. blue/red (2A)       +       ignition harness

Starter               dk. GREEN/ YELLOW       +       ign harn or starter       button (SRT-10)

Second Starter        PURPLE / brown       -       ignition harness
Notes: The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.

Ignition      pink/white              +       ignition harness
           
Accessory      same as second starter wire       -       ignition harness
Notes: The accessory wire is negative trigger thru a 610 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information.      
     
Power Lock      PURPLE / dk. green       -       DKP or cluster, sml gry plug, pin 3
Notes: Lock is negative trigger thru an 820 ohm resistor. Unlock is negative trigger thru a 330 ohm resistor. MUST use relays.
Can also use Directed interface module.

Power Unlock      same as power lock wire      
     
Lock Motor      lt. green       5wi      DKP or cluster, white plug, pin 10

Unlock Motor      tan/lt. green       5wi      DKP or cluster, white plug, pin 1

Parking Lights+      WHITE/ yel (L), WHITE/ gray (R)       +       harness at top of driver fender

Parking Lights-      WHITE/ lt. green       -       sw or cluster, sml gry plug, pin 5
Notes: Parking lights are negative trigger thru a 1130 ohm resistor. MUST use a relay.

Hazards      WHITE/ orange       -       sw or cluster, sml gry plug, pin 8
Notes: Hazards are negative trigger thru a 120 ohm resistor. MUST use a relay.

Turn Signal(L)      wht/lt grn (F), wht/dk grn (R)      +       harness at top of driver fender

Turn Signal(R)      WHITE/ tan (F), WHITE/ yel (R)       +       harness at top of driver fender

Reverse Light      WHITE/ lt. green       +       harness at top of driver fender

Door Trigger      see notes       -       each kick or cluster, lrg gray plug
Notes: The LF door is purple in pin 1. The RF door is PURPLE / white in pin 4. The LR door is PURPLE / orange or PURPLE / gray in pin 2. The RR door is purple / YELLOW or tan / YELLOW in pin 3. Use all four wires and diode isolate each wire from each other and the instrument cluster. See DirectFax document 1076 for wiring information.

Dome Supervision      yellow/lt. blue       +       A pillar or cluster, wht plg, pin 21
                 
Factory Alarm Arm      factory remote only
           
Factory Alarm Disarm      factory remote only
           
Disarm No Unlock      with ignition and Sentry Key
           
Tachometer      dk. blue/gray       ac       PCM, BLACK/ orange plug, pin 34
Notes: The PCM is on the passenger side firewall. The BLACK/ orange plug is the second plug down from the top.
On SRT-10 models, the tach wire is in the top black plug, pin 18.
On diesel models, the tach wire is at the ECM on the lower driver side of the engine, front 60 pin plug, pin 24, or at the camshaft position sensor just left of the ECM, in a 3 pin plug.
On gas models, can also go to any ignition coil or fuel injector and use the wire that is NOT BROWN / white.

Wait to start      see DirectFax document 1091            
Notes: On the remote start, make sure to program the Accessory State During Wait To Start to ON.

Brake Wire      WHITE/ tan       +       brake pedal switch

Parking Brake      dk. GREEN / WHITE       -       sw or cluster, lrg gry plug, pin 22

Horn Trigger      dk. GREEN/ purple       -       sw or cluster, lrg gry plug, pin 14
           
Interface Module:
   Category: Immobilizer Bypass      
   Required: Yes
   Type: Sentry Key
       Part #: 556UW
       Alternate Part1 #: DesignTech 20402
       Alternate Part2 #: DesignTech 29402
            Notes: Standard on all models except the ST.

Interface Module:
   Category: Door Lock Interface
   Required: No
   Type: Multiplex
       Part #: 456LW


Interface Module:
   Category: Combo Interface
   Required: No
   Type: Data Bus
       Part #: IOM-Chrysler-7
Notes: When using the IOM-Chrysler-7 it is not necessary to   use doc 1084. That part takes care of 2nd starter and accessory, locks, and bypass.


warning      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.






Posted By: warpedimage3
Date Posted: March 07, 2007 at 9:13 AM
Radio 12v      gray/red                +     radio harness

Radio Ground      black and BLACK/ lt. green -       radio harness      

Radio Ignition      (CAN data bus)      
           
Radio Illumination      N/A
                 
Factory Amp Turn-on      N/A
                 
Power Antenna      N/A      
           
LF Speaker +/-      dk. grn/yel - dk. grn/lt. blue      +,-      radio harness or amp behind glovebox     

RF Speaker +/-      gray / YELLOW - gray/lt. blue       +,-      radio harness or amp behind glovebox     

LR Speaker +/-      gray/lt. grn - gray/dk. grn       +,-      radio harness or amp behind glovebox     

RR Speaker +/-      dk. grn/lt. grn - dk. grn/gray      +,-      radio harness or amp behind glovebox     





Print Page | Close Window