Print Page | Close Window

Turn "ON" & "OFF" delay module,thermostatic switch

Printed From: the12volt.com
Forum Name: Mobile Video, GPS, and Navigation
Forum Discription: Mobile Video Head Units, DVD Players, LCD and TFT Monitors, Navigation, GPS, PS2, PS3, XBox, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=1588
Printed Date: October 31, 2024 at 6:33 PM


Topic: Turn "ON" & "OFF" delay module,thermostatic switch

Posted By: Dan M C
Subject: Turn "ON" & "OFF" delay module,thermostatic switch
Date Posted: June 29, 2002 at 12:13 PM

How would someone go into making a delayed on & off switch to reduce the thump,is there a company that has ready made units ?,one more thing about thermostatic switch for amps to cool down the amps,is there made ready units or not ?,or should i just use the remote turn on so the fans kick in with the rest of the stereo equipement .I apreciate any answer.

Thank you



-------------
Dan M C



Replies:

Posted By: Velocity Motors
Date Posted: June 29, 2002 at 9:48 PM

This kind of problem is often caused by transients in the signal processor as it powers down finding their way into the signal path, which the amplifier then transmits to the speakers.

Usually this can be solved by adding a little turn-off delay to the processor. This allows the processor to stay powered on for a short time after the amplifiers have powered down, thus preventing the pop.

Many components sold today (such as crossovers, equalizers, etc) have delays built-in. Read your manual to see if it is possible to set this delay on your piece of equipment or be sure to look for this feature during your next car audio purchase.

If your processor does not have this feature, you can build your own delay circuit with a diode and a capacitor. Add a 1N4004 diode in series with the processor's turn-on lead, striped side towards the EQ. Then add a capacitor in parallel, the (+) side of the cap connects to the striped (processor) side of the diode, the (-) side of the cap goes to ground (not the radio or EQ chassis - connect to the car chassis).

Experimenting with the cap value will give you the right amount of delay before the EQ shuts off. You don't want it too long, just long enough to make sure the amp is off before the EQ powers down. 220 - 1000 uF is about right, and make sure the cap is a polarized electrolytic, 16V or higher. Also keep in mind that the diode will introduce a 0.7V drop on the remote wire, which can cause the processor to power down before the rest of the system.

With the fans, I would wire then along with the remote turn on lead of the system so there is continuous cooling for the amplifiers.



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA




Posted By: Dan M C
Date Posted: June 29, 2002 at 11:26 PM
Thank you Jeff,again you came at the rescue site,i apreciate it very much !!!!posted_image

-------------
Dan M C




Posted By: Velocity Motors
Date Posted: June 30, 2002 at 8:53 AM

Not a problem, hope this helps you out.posted_image



-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA





Print Page | Close Window