Print Page | Close Window

Parrot CK3000 in 2006 A4

Printed From: the12volt.com
Forum Name: Cellular and Communications
Forum Discription: Cell Phones, Hands Free Kits, Bluetooth, Two Way Radios, CBs, Pagers, Wireless Internet, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=75029
Printed Date: July 01, 2025 at 7:30 AM


Topic: Parrot CK3000 in 2006 A4

Posted By: rkj
Subject: Parrot CK3000 in 2006 A4
Date Posted: March 24, 2006 at 12:59 PM

I plugged the CK3000 into my Symphony II (no BOSE, no NAV)and ran a quick test last night and a few issues need to be resolved before I can complete the install.

1) No power to orange wire when ignition on - I'm planning to tap the windshield washer circuit since it's switched by ignition and seldom used. Any thoughts on this plan or a better alternative?

2) I plugged the yellow mute wire into the Mute #3(blue). The stereo mutted and phone set up was audible, but stereo did not say "phone" as I was led to believe it would. Is this as good as it gets with this stereo?

3) Lastly, phone audio was very loud and distorted. I understant a 5k resistor will tone things down a bit. Which wire do I splice the resistor into (also I could only find a 4.7k resitor, close enough?)?

Thanks in advance for your input!

Robert



Replies:

Posted By: Customautomotiv
Date Posted: March 27, 2006 at 11:17 PM

You have to get ignition power at fusebox.

Yellow mute wire should plug into yelllow wire on secondary harness.

No resistors should be needed.


Print Page | Close Window