neon

Printed From: the12volt.com
Forum Name: Lights, Neon, LEDs, HIDs
Forum Discription: Under Car Lighting, Strobe Lights, Fog Lights, Headlights, HIDs, DRL, Tail Lights, Brake Lights, Dashboard Lights, WigWag, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=15766
Printed Date: August 15, 2025 at 3:52 AM

Topic: neon

Posted By: 01Accord
Subject: neon
Date Posted: July 02, 2003 at 12:31 AM

i have a '01 accord coupe. i wanted to hook up two 15" tubes onto one 3-prong switch. i already tried hooking both neons to the climate control power wire, but it blew a fuse. i don't want 2 blow another fuse or drill 2 get 2 the battery. is there any1 who can help me hook dem up. i don't know much about wiring.

-------------
Deep

Replies:

Posted By: robHI
Date Posted: July 02, 2003 at 1:36 AM

TRY THE DECK WIRE OR IGNITION WIRE 12v

Posted By: philaf
Date Posted: July 03, 2003 at 3:38 AM

three prong switch... kinda vague. i'm guessing that you have a lit switch, in which case the prongs are for 12v in, 12v out, and ground (hoping you grabbed a 12v switch, and not a 110v one)

hook the ground prong to ... a ground =)

hook the 12v out prong to your neons

hook the 12v in prong to a tap off your cig lighter, neons have a low enough draw that it shouldn't cause you any problems. i would put it on a fuse though, just in case.

Posted By: 2G Sport
Date Posted: July 03, 2003 at 7:04 AM

Did you accidentally touch wires when installing them the first time? Maybe you connected ground to the 12+ out by mistake. I have seen switches use a 1,2,3 numbering which can be confusing if you don't have the packaging. Most will use three lines(ground), a headlight looking icon(12+ out), and a + (12+ in). I agree that you should tap into the cigarette lighter + wire and fuse it. Good luck.

Print Page | Close Window