Print Page | Close Window

Is It Ok To Install A New 10” DVC Sub to Existing 3 12” SVC Set Up?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=146862
Printed Date: May 14, 2025 at 6:03 AM


Topic: Is It Ok To Install A New 10” DVC Sub to Existing 3 12” SVC Set Up?

Posted By: ascottbain
Subject: Is It Ok To Install A New 10” DVC Sub to Existing 3 12” SVC Set Up?
Date Posted: May 19, 2021 at 7:33 AM

I recently bought a 10” 4ohm DVC Powerbass M-10D Sub and built a fiberglass box for the rear fender. Currently I got 3- 12” SVC 4 ohm PB PS-12’s in a sealed box. I have a KENWOOD kac-7204 2-ch and a Alpine mrp-m500 mono. I also have a Profile ap1200 2ch and a Lanzar vibe-251. Any recommendations on best setup?
Pb12’s- 250rms-x3
Pb10   - 325rms-x1
Alpine. - 300 x 1@4 or 500 x 1@2
KWOD - 170 x 2@4 or 250 x 2@2 or 500x1 Bridged @4
Profile - 200 x 2@4 or 300 x2@2 or 600x1 Bridged @4
Vibe.    - 400 x 2@4 or 650 x2@2 or 1600x1 Bridged@4
Wiring 3 SVC subs , then adding a dvc confusing!Any additional info that’s needed don’t hesitate to ask. And thank you for any suggestions.

-------------
Ascottbain



Replies:

Posted By: DYohn
Date Posted: May 20, 2021 at 9:54 AM
To decide on your best wiring just consider the DVC as two SVC, making five voice coils in your setup. Just make sure not to place too low a total impedance load on your sub amp(s).

-------------
Support the12volt.com


Print Page | Close Window