Pioneer GM-2200 Amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=450
Printed Date: August 06, 2025 at 7:05 AM

Topic: Pioneer GM-2200 Amp

Posted By: danpegg
Subject: Pioneer GM-2200 Amp
Date Posted: April 25, 2002 at 7:45 AM

I have just been given a Pioneer GM-2200 and I am having problems getting it to work. On the amp there is no remote on connetor like on most other amps, the only other option I can think of to turn the amp on is the 3-pin connector. Is this correct?

Does anyone have this amp and know how to turn the amp on without using the correct connector?

-------------
Regards,
Dan

Replies:

Posted By: pat28ca
Date Posted: April 26, 2002 at 8:47 AM

you should do a search on the net for the amp if not search pioneer electronics and they have downloadable product manualss for every thing they have ever built.

Posted By: zippy
Date Posted: September 04, 2002 at 6:23 PM

Hi, like u i have been given one of these amplifiers and am having the same problem powering it up. Although i have tried searching the pioneer site but to no avail. If anyone does find away of doing it please let me know!

mike/zippy

Posted By: zippy
Date Posted: September 05, 2002 at 5:46 PM

I managed to get the amp powered up. I did draw a diagram to show it was done but i can't add it in ere so i'll explain!!

Basically connect up the battery to the amp as u would normally, but to turn it on you need to use the first two of the three pins on that 3-pin connector (pins 1 & 2 nearest the speaker connectors) and take them to battery + terminal connection on the amp and it turns on.

Hope this comes in usefull

mike/zippy

Print Page | Close Window