| PASSIVE ANTI-THEFT | YES | TRANSPONDER (Bypass or Data module required) | SEE NOTES |
| | | This vehicle is equipped with an IMMOBILIZER passive anti-theft system. Please refer to the diagram for proper bypass instructions. |
|
| 12 VOLTS | Red | Behind the fusebox on the left side of the dash | + |
| IGNITION | RED / blue | Pin-4 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| IGNITION 2 | GREEN/ gray & Green | Pin-12 and Pin-1 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| STARTER | RED / gray | Pin-3 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| STARTER 2 | RED / gray | Pin-11 on Ignition switch connector | + |
| | | See the provided document for exact pin locations. |
|
| KEY SENSE | Green | Pin-1 on Ignition switch connector | + |
| | | This wire is required for remote start and should be energized before ignition. |
|
| LOCK | White (1-3) | At module in driver's door | - |
| | | 1-wire system. Straight ground (-) to lock and ground through 180-ohm resistor to unlock. |
|
| UNLOCK | White (1-3) | At module in driver's door | - |
| | | 1-wire system. Straight ground (-) to lock and ground through 180-ohm resistor to unlock. |
|
| TRUNK RELEASE | GREEN/ black | In driver's door at switch | - |
| FACTORY ARM | Arms with lock | | |
| FACTORY DISARM | Through OEM remote only | | |
| | | Alarm will disarm automatically on remote start when the transponder is detected. |
|
| BRAKESWITCH | RED / black | In the driver's kickpanel | + |
| PARKLIGHTS | RED / blue & WHITE/ black | At the lightswtch in the dash | |
| | | This requires so special wiring, please refer to the parklight diagram. |
|