the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

08 tundra remote start


Post ReplyPost New Topic
< Prev Topic Next Topic >
Xlr8 
Member - Posts: 9
Member spacespace
Joined: May 19, 2002
Location: Newfoundland, Canada
Posted: February 04, 2008 at 8:45 PM / IP Logged  
Looking for this diagram, none here yet and I have one booked on friday.
Thanks
bbtaco 
Copper - Posts: 119
Copper spacespace
Joined: November 03, 2002
Location: Virginia, United States
Posted: February 04, 2008 at 9:14 PM / IP Logged  
Doorlocks/Windows       
Power Unlock RED (-) IN HARNESS IN DRIVERS KICKPANEL
PowerLock WHITE (-) IN HARNESS IN DRIVERS KICKPANEL
Driver Mtr Unlock BLUE/WHITE (+) IN HARNESS IN DRIVERS KICKPANEL
Driver Mtr Lock BLACK / YELLOW (+) IN HARNESS IN DRIVERS KICKPANEL
LF Window Up RED (REV) AT WINDOW SWITCH IN DRIVER DOOR
LF Window Dn GREEN (REV) AT WINDOW SWITCH IN DRIVER DOOR
RF Window Up RED (REV) AT WINDOW SWITCH IN PASSENGER DOOR
RF Window Dn GREEN (REV) AT WINDOW SWITCH IN PASSENGER DOOR
Remote Start       
Battery WHITE (+) IGNITION SWITCH HARNESS
Ignition 1 BLACK (+) IGNITION SWITCH HARNESS
Ignition 2 LIGHT GREEN (+) IGNITION SWITCH HARNESS
Accessory 1 GRAY (+) IGNITION SWITCH HARNESS
Starter 1 DARK GREEN (+) IGNITION SWITCH HARNESS
Anti-Theft Type UNIVERSAL IMMOBILIZER
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense GRAY OR LIGHT GREEN (-) IGNITION SWITCH HARNESS   
   AT BODY ELECTRONIC CONTROL MODULE IN DRIVER KICKPANEL, WIRE IS LIGHT GREEN AT BODY ELECTRONIC CONTROL MODULE
Tachometer WHITE (AC) AT DATA LINK CONNECTOR
   DATA LINK CONNECTOR IS LOCATED UNDER DASH ON DRIVER SIDE
Speed Sense YELLOW (AC) AT SKID CONTROL ECU AT BRAKE BOOSTER
Parking Lights GREEN (+) IN PLUG ON BOTTOM OF FUSE BOX
Brake Lights ORANGE (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Lights RED / BLACK (+) IN HARNESS IN DRIVERS KICKPANEL
Horn ORANGE (-) IN HARNESS AT STEERING COLUMN
Xlr8 
Member - Posts: 9
Member spacespace
Joined: May 19, 2002
Location: Newfoundland, Canada
Posted: February 04, 2008 at 9:16 PM / IP Logged  
Thanks man !
tonyberg 
Copper - Posts: 116
Copper spacespace
Joined: November 08, 2005
Location: North Dakota, United States
Posted: February 04, 2008 at 9:31 PM / IP Logged  
I didnt see a listing up there for arm/disarm...they are found in the drivers kick panel in a blue plug, the harness coming from the drivers door.  Pink for arm, will also control the door locks.  Disarm is blue, first pulse disarms and unlocks drivers door, 2nd pulse unlocks all doors.   To disarm without unlocking hook up keysense (grey) at ignition switch.  The arm/disarm wires are they VERY small wires in that blue plug...
Xlr8 
Member - Posts: 9
Member spacespace
Joined: May 19, 2002
Location: Newfoundland, Canada
Posted: February 04, 2008 at 10:17 PM / IP Logged  
good tip, quick too
thanks again guys
extreme1 
Silver - Posts: 1,070
Silver spacespace
Joined: February 12, 2003
Location: Canada
Posted: February 05, 2008 at 12:11 PM / IP Logged  
just be aware that most of your wires will be 24awg or smaller. you cannot use power at the ignition harness, use the large black wire going into the fuse panel.
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
throwback2332 
Member - Posts: 41
Member spacespace
Joined: May 18, 2005
Posted: February 05, 2008 at 10:49 PM / IP Logged  
I'm doing my 07 tundra now, the arm and disarm are in the same harness with the power door locks. They are
Arm with Lock (-) Lt. Blue - DKP
Disarm with Unlock (-) Pink - DKP
* Use these wires to make your factory alarm work side-by-side with your aftermarket unit.
I also tapped into the factory gbs sensor module and found the output in which i tied into my my aftermarket alarm.
If it's not custom, then it's not you.
throwback2332 
Member - Posts: 41
Member spacespace
Joined: May 18, 2005
Posted: February 05, 2008 at 10:54 PM / IP Logged  
I also ran a 10 guage amp kit for the remote start acc wires from the fuse box under the hood. First toyota ive seen with 20 guage or smaller wire in the igntion.
If it's not custom, then it's not you.
Mike M2 
Platinum - Posts: 2,652
Platinum spacespace
Joined: June 29, 2005
Location: United States
Posted: February 06, 2008 at 6:56 AM / IP Logged  
I always use the fat black wire on the front of the fuse box....
Mike M2
Tech Manager
CS Dealer Services
throwback2332 
Member - Posts: 41
Member spacespace
Joined: May 18, 2005
Posted: February 06, 2008 at 7:26 PM / IP Logged  
Hey I have the PKT2 module to bypass the immobilizer, when you get yours done can you me so insight on it. Thanks
If it's not custom, then it's not you.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer