ford focus 530t module wiring?

I have a couple of questions...

For the motor wiring of both driver and passenger doors, this can all be hooked up after the drivers 'master' window switches in the drivers door only, correct?

I don't have to run the motor wires from the 530 to both doors I'm assuming....

For the one touch feature for both driver and passenger, I HAVE to run the switch wires into both doors, right?

My drivers side has a factory one-touch down feature...I should hook the module up on the motor side AFTER the module?

And finally, I have to cut the wires from the OEM switches on the motor side for both up and down?

Thanks

Oh...I can't send power to the passenger motor from the drivers side passenger switch?

I mean, if I hook up the switch side of the 530T to the passenger switch, but instead of running the motor power wires

into the passenger door, hook them to the drivers side passenger switch, it should work okay, correct?

You will have to run the switch wires and the motor wires to the passenger side.

hello there i need some help with 2 530t  ,question is when get one 530 t connected to the  remote starter ,do i have to repeat same installation for the other one?,i mean im using one 530 for one front door and one back door  right side and the other front and left door another 530t  im talking about the small gauge wires , cause maybe i need to bring them to the drivers side  right? also the gray wire do i need  to connect it?or not? thanks