dodge journey remote start

ok, I found that is like Caravan 2008, and XK06 with firmware SICH1 gonna works with.Andy

Use the module that Fortin Makes....You must use a Compustar or comparable model to make it work but it will not void the vehicles warranty as a XK06 needs to be hard wired into the module next to the key cilinder.  You damage that module and you will be guaranteed a visit to the Dealer for a pretty penny. Go to ifar.ca and search that vehicle.

this car is very easy to do if you solder to the other board. hard to mess up if go to the inside board. it takes me 15 min to remove, solder and replace. i am impressed with the fortin piece, but its not really a time saver cuz your still doing the same amount of work and you still have to use another module for everything else or hardwire. it wont be long before someone just makes that add on circuit board and then you could connect any module without soldering. anyways i have used everything available for these cars and the idatalink piece is by far the best. one module that does everything igniton, locks, transponder and also gives you brake, parking light and tach outputs.

I recommend you xk06 bypasskit.com

dtk1 wrote: I recommend you xk06 bypasskit.com

xko6 plus a pku-ch2 plus a xk07 (if you have the right data port) hmmm!

Idatalink ADS-AL-CA + ADS-RNGC2 easiest install, EASIEST transponder programming.Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

i agree. you can also use ads-dlsl-ch3 which comes with the ring