alarm uninstalled, power lock dont work

After spending 3 long nights, I have successfully uninstalled the alarm that the previous owner installed ( Clifford 50.5x and Immobilizer Securitech (Asia) Ltd. TES-761 Immobiliser )on my Honda S2000; well at least the car started back up and everything running except the power door locks.       I have traced every wire and disconnect them and return them to original form. My question is how does the stock power locks react when you insert a key to unlock the door?     There seem to be no power to the lock motors at all, and seem stiff to lock the doors manually from the inside...And where should I look to solve this problem? Did I remove 1 extra relay? ( I dont have OEM Honda Alarm) I have removed 3 sets of relays. 2 being behind the driver seat, and 1 under the dash. I assume: 1 is Fuel Cut relay 1 is Trunk Release 1 is Door locks??? I will look into the doors this weekend and see if they did something at the doors.

Shouldn't have needed relays for the door locks, check your car's fuses. Can We merge all of these posts please Mr. Moderators?

Sorry should have added unless there was priority unlocking, drivers side first in which case if they WERE lock relay(s) join the 87a and 30 wires.

howie ll wrote: Shouldn't have needed relays for the door locks, check your car's fuses. Can We merge all of these posts please Mr. Moderators?

Good point about the fuses! It may have been removed on purposely. Yea I know you dont need relays thats why I have already unstalled them. And have a fresh start for my new alarm.

fixed! the previous installer rewired the power lock at the door... i guess he couldnt figure out how to do it the correct way.