compustar cm4200 issues

Hi all, i installed an cm4200 in my 90 crx(manual tranny). the issue i am having is with the horn output no honk(use a relay every way you possibly can to get to work but nothing), also my door trigger is not setting the brain off when i open the door when car is armed and last the remote start is not cranking everything work light flash dash lights come on fuel pump evrything but no crank and if i am inside the car and remote start it with my foot down on the car fires right up, now the reason i purchased a compustar unit is because i thought u wouldnt have 2 bypass the clutch, i even tryed hooking up the lutch wire to the - status wire from cn2 i normally purchase dei units but this is my first compustar. i have wiring ass followed

cn1

red-12v-connected to wht in column harness

grn/wht-parking lights-connected to RED / grn kick panel

RED / wht-12v(piggy backed red)

white-acc-yellow column harness

blue-not used

grn/red-ign-blk/ylw column harness

blk-ground

cn2

grn/wht-not used

RED / black-starter output-tried to clutch nothing

violet-output to starter kill-to relay

black-- status output-tryed 2 clutch as well

org-not used

wht-horn output-connected to blu/red  (relayed different ways to get horn to work and nothing

cn3

lt blu- e brake- connected to grn/red-kick panel

gry/blk -not used-hoodpin

lt blu/wht-brake-connected to brake wire @ switch

vio/blk-trunk trigger-not used

RED / wht-(-) door trigger- connected to - grn/red-drivers kick

red-(+) door trigger-not used

brn/blk-glo plug-not used

bwn/wht-glo plug-not used

ylw/blk-tach-connect to blue wire @ dist.

cn3-not used

i have programmed remotes, tach learned and put in reservation mode, all dip switchs and jumpers are correct to book, your help is very appriciated and welcome, thanks and hope to hear from someone, i am thinking my unit is bad....