remote start take over is not working

Hi all

Car: Infiniti M56 2011

remote start: compustar  FT-6200S-CONT

bypass: Datalink ads-al ca

the car will remote start without any problem but the issue when i enter my car and press the brake it shuts down and  the ignition turns to "On"... i press the button to get it back to off and start the car and this error comes to the  screen.

Hi, this seems like you connected your (+) Brake pedal input from the compustar to the vehicle.

If you want the ADS module to handle take over for you, you must make sure you use Data brake pedal status not hardwired. Using data brake pedal status will delay the brake status output after the push button pulses are sent. Right now your remote starter receives the brake status before the pulses are sent.

i have connect the brake input to the ADS.

if i change to manuale take over whould it fix the issue for me?

and what about the error ? i'm afraid it will make an issue to to the system in the future.