2008 mazda3 door lock and unlock

jaxzin wrote: howie ll wrote: WHITE/ black, pin Y of that 46 pin plug marked JO5. Thank you so much. Will report back once I have it all installed.

Alarm has been working great for the past couple of weeks. I just have to play with getting the shock sensor just right since it seems to be a bit sensitive. Planning on adding a glass break sensor and a battery back up. I didnt add the ignition controlled doo rlock and unlock because I couldnt figure out to how wire both of those to the 1 wire with the resistor.

Nothing to wire, it's in the programming.

OK. This alarm has been reliable and working great for a couple of months now. I want to add the automatic door lock and unlock feature that is built into the 727T. Would this work coming off of the 727T module?

Try programming it, no reason why not.

Im from canada..and i have 2007 M3 Sedan Auto Trans with keyless entry...i bought a compustar 6000AS..im in need of help of how i am going to connect the unlock wire and lock wire and door trigger input of the aftermarket alarm to my car..it says that my car has one wire unlock and lock system "(lock is a negative trigger thru a 1000 ohm resistor, unlock is a straight negative trigger, must use relays!!)", how would i connect if id like a driver priority unlock??..and for door trigger it says "diode isolate each", how do i connect the diodes to alarm wire door trigger input (where is the anode side and cathode side?)??..anyone can explain this into more detail?? thanks a lot..