dvc and amp connection

* Another reason why I asked about RMS vs. Max.

Hi guys I just got a hold of my manual for my amplifier and the specs are as follows : Max power out put 4ohm stereo or mono - 600w x 2ch Continuos power output 4ohm stereo or mono - 40w x 2ch Max power output 4ohm bridge mono - 900w x 1ch Continuous power output 4ohm bridge mono - 130w x 1ch Continuous power output 2ohm stereo or mono - 65w x 2ch Frequency response +/- 1db - 10hz-50khz Total harmonic distortion - >0.05% with 80hz BPF Signal to noise ratio(aiweighted) - >97db Input sensitivity - 250mv-4v Input impedance - 20k ohm Channel seperation - >50db Damping factor - >180db Output impendance - 2ohm High pass filter frequency - 80hz Low pass filter frequency - 120hz

I hope this helps and could clear stuff up so a solution can be concluded. Thanx

Follow the procedure laid out by Haemphyst. Being newer here, I simply did not want to come in and promptly start accusing others of supplying bad information, so I detailed how to wire the coils IF you had an amp that could bridge a 2-ohm load (and there are high end ones that can) while I tried to find more details on the amplifier. I guess I won't be doing that again. (No offense to you personally Viruz.)

None taken, its ok to advise , I mean u guys know so much more than I do and we learn somethin new everyday I will follow the haemp Thanx