07 ford fusion remote start

also, just for shiggles, anybody else know which wire to tap?

I've done it using relays on many cars no issues to speak ofIf i Can't Install it    I Don't need it   Joe

LOCK MOTOR WIRE      GRAY/BROWN (5-WIRE TYPE)      IN DRIVERS KICK PANEL 

This wire should test as (+) pulse with a Lock command.

86 12v from GRAY/BROWN lock motor IN DRIVERS KICK PANEL 

85 ground 87 ground 30 out to R/S (-) activation input wire

Soldering is fun!

No dice. Not getting 12v on that wire

It will only get a pulse 12v when the lock is activatedIf i Can't Install it    I Don't need it   Joe

nothing when locking

Keep looking you must have the wrong wire.If i Can't Install it    I Don't need it   Joe

chev104275 wrote: Keep looking you must have the wrong wire.

there is only one gray/brown wire on the smart junction box connector E, which is where more than one wiring guide has pointed me to in order to get that wire. I tried 2 different relays thinking one may have been bad. Still cant figure it out. Going to borrow an analog volt meter (mine is a cheaper digital one) and see if that helps me find it. Is there any other wires that can be used for this function? I really appreciate your assistance btw, and if i sounded short earlier it's because my fingers were frozen and i couldnt type. LoL.

You should be able to grab it in the driver's kick panel as well as the harness coming from the door.If i Can't Install it    I Don't need it   Joe