2013 nissan sentra, non smart key or pts

hello, ill be using a CA6554 with flashlogic FLCAN for immobilizer i have seen on a few other sites that some people have been having issues with the 2013 sentra throwing CEL on. has anyone had this issue? i see that this car does not have second start, only 2nd acc... now, has anyone on here had this issue with any remote starts? if so what can i do to get around it?

Could be a timing issue making sure the connections are setup correctly (ing as ing and acc as acc) 12 VOLT CONSTANT      GREEN (+)      @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 3      STARTER      BLUE (+)    @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 2 IGNITION 1      RED (+)      @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 1            ACCESSORY /HEATER BLOWER 1      PINK (+)      @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 4       ACCESSORY /HEATER BLOWER 2      WHITE (+)      @ IGNITION SWITCH, WHITE 6-PIN PLUG, PIN 5 If i Can't Install it    I Don't need it   Joe

isolate your start wire with a diode inlineTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

tedmond wrote: isolate your start wire with a diode inline

Some people have said that. Do you think a 3 amp will be suffice? Or do I need anything more than that?

i would use 6amp to be safeTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Cool. All I have is 3amp. Might have to run somewhere to get one then thanks

doesnt hurt to use 3 amp to see if that helps rid of the CEL issue. if the issue is resolved go purchase 6ampsTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

I would just put two of the 3-amps in parallel.