remote start blinks

Home / the12volt's Install Bay / Car Security and Convenience / remote start blinks

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

ricardoboston

Copper - Posts: 268

This member has made a donation to the12volt.com. Click here for more info.

Joined: May 11, 2009

Location: Massachusetts, United States

Posted: October 10, 2016 at 6:44 PM / IP Logged

hello i got a 2008 nissan altima from a customer and he says that he got a new battery replaced on the car and after that, his remote start wouldn't start anymore.so i took the dash off and i have checked the remote start brain and its blinking a lot the red light so i think it get freeze or something happen to the brain, is there anything that i can do to make it stop blinking

Back to Top

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: October 11, 2016 at 2:44 AM / IP Logged

Pull all connectors from unit and short positive and negative together.

IF you can get into programming and have all the remotes you can delete all remotes and re-pair them.

If you have a bitwriter you can ZAP it to try and reset it.

Back to Top

ricardoboston

Copper - Posts: 268

Joined: May 11, 2009

Location: Massachusetts, United States

Posted: October 11, 2016 at 5:21 AM / IP Logged

i did but i did it different i ve ben told to have everything disconnected ground the WHITE/ blue and then get the have gauge back to the brain ? i will try your way thanks

Back to Top

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: October 11, 2016 at 6:42 AM / IP Logged

I guessed it is a DEI brand.

IF not post the brand and model

Back to Top

ricardoboston

Copper - Posts: 268

Joined: May 11, 2009

Location: Massachusetts, United States

Posted: October 11, 2016 at 8:39 AM / IP Logged

avital 4103

Back to Top

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: October 11, 2016 at 12:41 PM / IP Logged

Yup same unit sitting here right now. Installed once in a friends car then he got a new car so he had me remove it and I'm waiting on him to install it in his new vehicle.

With unit un plugged you will need to connect Pin H1/8 Black Ground to either or both upper outside heavy gauge Pins.

Back to Top

ricardoboston

Copper - Posts: 268

Joined: May 11, 2009

Location: Massachusetts, United States

Posted: October 15, 2016 at 8:38 PM / IP Logged

that is like a hard reset, right?

Back to Top

lurch228

Silver - Posts: 1,338

Joined: August 08, 2012

Posted: October 16, 2016 at 1:53 AM / IP Logged

It pulls a residual power from the unit to try and reset last state.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.