the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2002 Lexus GS430 Remote Start, CM7200-s Install Guide


Post ReplyPost New Topic
< Prev Topic Next Topic >
savage24x 
Member - Posts: 2
Member spacespace
Joined: November 01, 2017
Location: New Jersey, United States
Posted: November 01, 2017 at 1:07 PM / IP Logged  
Hi everyone, I am purchasing a Compustar FT-7200S-CONT and a Blade-AL for my 2002 Lexus GS430. I have the wiring for the Blade, but not the compustar ft-7200s-CONT. I have the master, but does anyone have a specific 01-05 gs430 diagram for the 7200S?
Thanks!
kreg357 
Platinum - Posts: 7,781
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Electrical Theory. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: January 30, 2009
Location: Pennsylvania, United States
Posted: November 03, 2017 at 5:28 AM / IP Logged  
Basic wiring :
High Current Ignition
1 Red   +12V     WHITE/BLUE (+) @ IGNITION SWITCH HARNESS
2 Green/White (+) Parking Lights            possibly GREEN (+) @ BOTTOM RIGHT OF FUSE PANEL
3 Red/White      +12V     WHITE/BLUE (+) @ IGNITION SWITCH HARNESS       
4 WhiteAccessory           BLUE/YELLOW (+) @ IGNITION SWITCH HARNESS
5 Blue   Ignition2             BLACK/WHITE (+) @ IGNITION SWITCH HARNESS
6 YellowStarter BLACK (+) @ IGNITION SWITCH HARNESS
7 Green Ignition1             BLACK/YELLOW (+) @ IGNITION SWITCH HARNESS
8 Black Chassis Ground Chassis Ground
20 Pin Harness ( necessary wires )
4 Light Blue/White     Brake   GREEN/WHITE (+) @ 20-PIN PLUG, IN DRIVERS KICK PANEL     
          or @ BRAKE PEDAL SWITCH
5 Blue/Black Lock     BLUE/BLACK      @ DRIVER'S KEY CYL.
7 Blue            Unlock BLUE/WHITE        @ DRIVER'S KEY CYL
13 Violet White           Trunk Release *w/relay BLUE (+) @ 18-PIN PLUG, IN DRIVERS KICK PANEL
15 Black        GWR    Keysense YELLOW (-) @ IGNITION SWITCH HARNESS
17 Green/White           (-) Parking Lights            possibly RED/YELLOW (-) UNDER STEERING COLUMN
18 Yellow/Black          Tach     BLACK/YELLOW @ PIN 16, IN 28-PIN PLUG INSIDE ECU BOX
There are some wiring guide differences on this car. Careful testing is required. Areas of concern :
1. Locks and alarm. Omega shows lock wires at the drivers door cylinder. This would be easiest but
     requires passing wires into the door. Bulldog shows a special wiring with diodes and CM7200s
     programming. These wires are also inside the drivers door. Here is a link to the Bulldog info :
http://diagrams.marktoonen.nl/DOWNLOADS/7376_GS430_TOYOTA%20and%20LEXUS%20door%20lock%20interface.pdf
2. Parking Lights. Bulldog shows both (+) and (-) wires for the Parking Lights while Omega shows
     only the Hazards. If you can locate, test and verify a Parking Light wire, that would be preferable
     to the Hazards. Better yet, if the (-) Parking Light wire is a viable option, then you could set a
     jumper 3 on the CM7200s to switch the Green/White (+) Parking Light output over to (+) Trunk
     Release. This would allow a direct connection to the (+) Trunk Release wire and eliminate the
     extra relay required if you used the (-) Trunk Release wire.
3 Trunk Release. As mentioned above, if you use the (-) Parking Light wire, you can free up the
     thick Green/White wire for the truck release. If you have to use the Violet/White wire, you need
     a 30/40 Amp SPDT relay with fuse holder and 10 Amp fuse.
Soldering is fun!
savage24x 
Member - Posts: 2
Member spacespace
Joined: November 01, 2017
Location: New Jersey, United States
Posted: November 03, 2017 at 7:33 AM / IP Logged  
Wow, thank you so much! Been looking everywhere for that and don’t have access to computation manuals. Really appreciate it.
kreg357 
Platinum - Posts: 7,781
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Electrical Theory. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: January 30, 2009
Location: Pennsylvania, United States
Posted: November 03, 2017 at 8:10 AM / IP Logged  
I just uploaded the full CM7200-s install guide. Here is a link to the install guide :
https://www.the12volt.com/installbay/file.asp?ID=1399
Soldering is fun!

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer