2017 Jeep Wrangler Base Remote Start

I'm adding power locks and a remote starter to a 17 JKU, I got the actuators all installed and working. The remote start on the other hand, not so much. I'm using the Avital 4105L with a Fortin EvoRS-chrt5, I was told to connect all the Avital wires to the fortin, when I do that nothing happens. I ran a wire from the starter output under the engine fuse box and now the avital engages and the Jeep will crank, but it never fires up. Evo Avital Yellow (Ignition) ---- Pink Purple (Lock/Arm) ---- Green/White Purple/White(Unlock/Disarm) ---- Light Green Green (Door Status) White (Trunk Status) Orange (Sliding Door, left) Orange/Black (sliding Door, right) Dark Blue (Ground when running) ---- Orange Red/Blue (Starter) ---- Purple Light/Blue (Not used) Black (Brake) ---- Brown Pink (Tach) ---- Purple/White Yellow/Black(Trunk Release) Brown/White (HandBrake) ---- Black/White Pink/Black (Hood Status) ---- Gray (Also has aftermarket pin switch T-in) 2 power wires on the Avital are ran under the hood to the battery Avital - Pink/White and Orange are not connected to anything Avital - Satellite Harness is not connected Evo - Data Link 4 pin is not connected to anything, the T of the data link, I do have the main data link plugged into the evo. I did the programming on the evo and it seems to have worked.