2012 Honda Pilot Key, 4806V and Idatalink ADS AL DL

Hello everyone I am doing this car tomorrow and here is what I will follow on the diagram. Please advise me if I am wrong and what need to be added. Thanks Installation type #1 REMOTES START 8-PIN Red/black, red/white and Red 12volt to 12volt WHITE 50Am in car (ign switch) Pink/Black NC Pink ignition 1 to ignition PINK in car Pink/white NC Violet starter (+) to starter YELLOW in car Orange (+) accessory to accessory ORANGE in car Which wire from Remote start I can connect to second accessory RED in car? Is it the #21 VIOLET/BROWN from the remote starter 24-pin harness? Between Remote start and ADS: I connect using D2D RS #12 VIOLET/WHITE Tach input to PURPLE/WHITE tach (AC) output in ADS ON ADS-AL(DL): white/black ignition to CUT ignition in car at the connector side White/red igntion to CUT ignition in car at the car side Brown/Red CANH to CANH in car Brown/yellow CANL to CANL in car ORANGE/black Key Data to Data in Car PINK ignition tap onto PINK in RS dcd

wyciwug wrote: REMOTES START 8-PIN Red/black, red/white and Red 12volt to 12volt WHITE 50Am in car (ign switch) Pink/Black NC Pink ignition 1 to ignition PINK in car Pink/white NC Violet starter (+) to starter YELLOW in car Orange (+) accessory to accessory ORANGE in car Which wire from Remote start I can connect to second accessory RED in car? Is it the #21 VIOLET/BROWN from the remote starter 24-pin harness?

Looking at the manual on this site, pin 21 is a violet/yellow negative starter output. Don't use that. The Pink/white wire from the remote start heavy gauge harness is IGN2 by default but can be programmed to ACC2.My ex once told me I have a perfect face for radio.

thank you very much can you also point me out which wire from remote start i use to turn off auto headlight after car shut down? thanksdcd

I don't know for sure, but you could see if opening the door after remote start shutdown works. If it does, you could pulse the door trigger wire, but you should probably relay isolate it to prevent setting off the Viper. Alternatively, you may be able to interrupt the headlight wire at the switch during remote start.My ex once told me I have a perfect face for radio.

Hello I got it working. The bypass did all the job shutting down the light after remote start shut downdcd