the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Options to Use 1 Negative Wire to Control Power Windows?


Post ReplyPost New Topic
< Prev Topic Next Topic >
r3drum 
Member - Posts: 1
Member spacespace
Joined: September 19, 2020
Location: California, United States
Posted: September 19, 2020 at 1:32 PM / IP Logged Link to Post Post Reply Quote r3drum
Hey all! I'm helping a friend who wants to use his power window control switch in his 2001 Dodge RAM 1500 to control his power windows. Issue is, he purchased the passenger door from eBay which has built in power windows and door locks with controls on the door. Because his truck was a base model and did not have those options, I'm trying to wire it with relays or a window switch module, but the way his OEM power window control works, 1 wire (yellow) sends a "negative" whenever you toggle the control to open or close the window. The other 4 wires connect to the power window motor to make it go up/down. Are there any wiring options outside of the standard 2 relay with 2 negative trigger set up or is there a module to purchase that can use the 1 trigger wire? I'm not aware of one and really unclear how Dodge would control the power window the way it's currently wired.
More info:
I've installed an after market power window kit and power door lock kit on the driver door and have it wired to his alarm so that both driver and passenger windows roll up and doors lock when it is armed. I installed 2 window switches in the center console that controls both his windows independently (up/down). But again, he wants to use the OEM controls on passenger door to control the passenger window and door lock switch to lock/unlock both driver/passenger doors.
Thanks in advance for any help!
tonanzith 
Gold - Posts: 593
Gold spaceThis member consistently provides reliable informationspace
Joined: July 18, 2008
Location: Washington, United States
Posted: September 22, 2020 at 12:47 PM / IP Logged Link to Post Post Reply Quote tonanzith
without knowing exact part numbers if you get the same gnd signal for up AND down on that switch then that is likely parts for a can bus or similar system not controlled inside the door.   basically its data and your not going to be able to use it for what you want.
Gary Sather

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, February 3, 2023 • Copyright © 1999-2023 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer