MB Quart NA2-400.2 Amp Clarification

Home / the12volt's Install Bay / Car Audio / MB Quart NA2-400.2 Amp Clarification

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

dertitan2

Member - Posts: 12

Joined: September 30, 2009

Location: North Carolina, United States

Posted: September 23, 2020 at 3:08 PM / IP Logged

MB Quart NA2-400.2 Powersport amp stats the following: "This switch will set the amplifier to have a full frequency output or to filter out high or low frequencies. The NA1-400.2 offers either a bandpass or a high pass filter." I am getting myself confused, you can select HP or OFF or LP, the manual states the amp has a 60hz subsonic filter, now where I am confused is this subsonic filter at 60 when it is set to off or other, i ask this because this is going to be feeding a set of polk audio db652 2 way 6.5" speakers on a motorcycle in the faring, Polk audio advised me to set the HP amp to 60, but if the subsonic is at 60 not need to adjust HP

I am probably just over reading what the manual says

Direction and clarification would be appreciated

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.