Remote Starting a Stationary Engine

Home / the12volt's Install Bay / Car Security and Convenience / Remote Starting a Stationary Engine

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

davedb

Member - Posts: 1

Joined: March 19, 2020

Location: United Kingdom

Posted: November 15, 2020 at 2:06 AM / IP Logged

Hello all I’m looking to remotely start a compressor engine used to blow out slurry pipes I have a remote control already the outputs are a momentary signal (one for start and one for stop) what I need is a circuit that will turn on the ignition, run a heater plug for 20-30 seconds and then engage starter until it fires

The engine has a oil pressure switch and Alternator charging light could these be used to turn off the starter when started? I’d also need some kind of timer so if the engine didn’t start it wouldn’t keep cranking any help would be much appreciated

Thanks

Dave

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.