the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

falsing dei 507t


Post ReplyPost New Topic
< Prev Topic Next Topic >
larkster 
Copper - Posts: 98
Copper spacespace
Joined: October 04, 2003
Location: Canada
Posted: September 14, 2004 at 10:51 PM / IP Logged  

i have installed one of the dei 507t motion tilt sensor in a 2003 subaru legacy.  with a compustar 2wfas.  the problem i am having is the alarm falses but only in the morning. about 2 minutes after it is armed.  it just goes off.  over and over again.  I have tested everything over and over again and only come back to one thing and that is a faulty sensor.  I have the settings on 1 degree medium motion and 10 second delay.  the sensor is installed in the center console and is activated off the negative when armed.  there is nothing else on that wire.  I have tried mounting it in other postions with still the same results.  The customer has left it with me to fix it.  And i have it until i do.   The thing that boggles my mind is it is fine the rest of the day it only falses in the morning......any ideas..... anybody installed many of these sensors.  i have only installed one other of the tilt motion sensors and never had a problem before.....

any ideas would be greatly appreciated

its_radio_shop 
Copper - Posts: 76
Copper spacespace
Joined: March 16, 2004
Location: United States
Posted: September 15, 2004 at 10:10 AM / IP Logged  
Not familiar with that exact tilt sensor but the Clifford sensor requires more than 1 degree of tilt to trigger. Is your sensor adjustable? I would try a different setting if it is. The cooler temperature in the morning may be causing the sensor to be more sensitive although its hard to say without any direct experience with it.
Big Dog 
Gold - Posts: 1,265
Gold spaceThis member consistently provides reliable informationspace
Joined: May 02, 2002
Location: Quebec, Canada
Posted: September 15, 2004 at 11:25 AM / IP Logged  
Try 3 degrees and medium motion . ..
Don't forget that when facing the dipswitches, to flip dipswitch ON it must be in the DOWN position (opposite of a light switch in your home). . . falsing dei 507t - Last Post -- posted image.
So when dipswitch 1 is closer to PCBoard, the position is 1 degree, whereas away from PCBoard is 3 degrees. Same goes for other settings.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer