the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Sirius question


Post ReplyPost New Topic
< Prev Topic Next Topic >
2Jeepsdeep 
Member - Posts: 12
Member spacespace
Joined: October 08, 2004
Location: United States
Posted: November 09, 2004 at 8:37 PM / IP Logged  

i think i'm going to change out my tuner for a different one

anyone know where i can get the older 901 kenwood tuner? i want that one as it uses the duel input antenna and i already have that type of antenna installed

thanks!

oldsbravo5 
Member - Posts: 41
Member spacespace
Joined: March 05, 2004
Location: United States
Posted: November 09, 2004 at 8:43 PM / IP Logged  
Make sure you have 12 volts at the tuner.  I had the same problem only in XM form, and it turned out I had a bad ground.  After I repositioned the ground, everything was a-ok. 
Bravadas are cool
Javelin3o4 
Copper - Posts: 239
Copper spacespace
Joined: August 22, 2003
Location: United States
Posted: November 09, 2004 at 10:18 PM / IP Logged  
check the pins on the cable, make sure none are bent, also make sure that none are pused in, ive seen sometimes the pins will get pushed back into the plug so when its plugged in the pin wont make contact with the connector inside the deck/tuner
2Jeepsdeep 
Member - Posts: 12
Member spacespace
Joined: October 08, 2004
Location: United States
Posted: November 10, 2004 at 1:08 AM / IP Logged  

all the pins are good, the tuner is supposed to get the ground through the cable to the head unit

but i think i'll go try running a seperate ground wire to make sure that's working

2Jeepsdeep 
Member - Posts: 12
Member spacespace
Joined: October 08, 2004
Location: United States
Posted: November 10, 2004 at 12:23 PM / IP Logged  

i ran a seperate ground and it worked, but when i moved the ground to a more secure place it stopped working

i've tried a few different places and still no go;

fuseblower 
Silver - Posts: 403
Silver spacespace
Joined: June 25, 2003
Location: United States
Posted: November 10, 2004 at 12:40 PM / IP Logged  

Sounds like you may have a wire that is broken on the inside of your connecting cable of that you have a bad pc board in your turner.

I would assume this because when you move the unit it works and than sometimes it does not.  keep everything plug up and carefully move your sirus tuner around and see what happens.  Also, play with the cables while the unit is on and see if it turns on and off as you play with the wires.

2Jeepsdeep 
Member - Posts: 12
Member spacespace
Joined: October 08, 2004
Location: United States
Posted: November 10, 2004 at 12:43 PM / IP Logged  

the connnection cable is brand new and i've tested each pin and they have conductivity; i would suspect the tuner as it was bought off ebay in "as-is, untested" condition

Page of 2

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, April 19, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer