possible blue remote wire problem

yeah, i think its your ground, change your ground out. And see what happends2 Memphis HPO 12s

1 Memphis 1000D

2 Memphis 8s

1 Memphis MC200

4 Memphis 3way 6 1/2s

1 Memphis MC3004

4 Memphis Tweeters

1 Memphis 3-way electronic crossover

2 Memphis 5 1/4

2 Memphis 4s

all right, i will just get a new ground cable, but the wierd thing is that ive only had the system for just about a week and a half now though...but i guess its worth a try, thanks again. -dwh2-

the last thing i can think of is, you might not want to hear this. But, I have seen in many cases like yours...someone have a bad ground, or loose fuse, or something that causes sudden loss of ground or power, well over time, this will ruin the amp. If the new ground doesnt fix it. I would suggest pulling the amp out, and taking in to a shop and have it bench tested. So them you will know for sure. Hope that helps. Out2 Memphis HPO 12s

1 Memphis 1000D

2 Memphis 8s

1 Memphis MC200

4 Memphis 3way 6 1/2s

1 Memphis MC3004

4 Memphis Tweeters

1 Memphis 3-way electronic crossover

2 Memphis 5 1/4

2 Memphis 4s

another thing, dont just change the cable...change the point of contact2 Memphis HPO 12s

1 Memphis 1000D

2 Memphis 8s

1 Memphis MC200

4 Memphis 3way 6 1/2s

1 Memphis MC3004

4 Memphis Tweeters

1 Memphis 3-way electronic crossover

2 Memphis 5 1/4

2 Memphis 4s

i have the same issue.the remote slot ffrom the deck is bad i think so i was gonna set up a toggle switch for the amp on and of.im thinking of setting up the toggle switch in the ashtray spotin the front part of the counsel.anyone know how to set up this?i was thinking of getting the 12v power from the ashtray light.the toggle switch is a light up so it has 3 slots.anyone have any ideas on how to go about this?

Mr.toadman wrote: i have the same issue.the remote slot ffrom the deck is bad i think so i was gonna set up a toggle switch for the amp on and of.im thinking of setting up the toggle switch in the ashtray spotin the front part of the counsel.anyone know how to set up this?i was thinking of getting the 12v power from the ashtray light.the toggle switch is a light up so it has 3 slots.anyone have any ideas on how to go about this?

Hook a ground to the frame first to the switch, Then one end to the amp the other from a power source from the battery or fuse block.

so i could just run a 16gauge wire from the + of the battery to this little switch?the pain would be to half to turn it off each time but ill have to sacrifice it lol as my deck is manually turned off as well.i couldnt find the iginition wire to splice into the deck power.it has the steeringwheel remotes so there was a mess there.where else could i get a 12v power source?ive heard the blue wire from the cigarrett lighter.help help me car is torn apart lol