2001 monte carlo remote start
Welcome Guest :)
danh0ward
Member -
Posts: 12
Joined: September 03, 2004
Location: United States
Posted: December 14, 2004 at 12:41 PM / IP Logged
I need a rs diagram for a 2001 chev monte carlo thanks
Dan Howard
rudbwoy69camaro
Silver -
Posts: 350
Joined: June 10, 2003
Location: United States
Posted: December 14, 2004 at 2:23 PM / IP Logged
2001 Chevrolet Monte Carlo | Item | Wire Color | Polarity | Wire Location |
| 12V | red | + | ignition harness *1 |
| STARTER | yellow | + | ignition harness *1 |
| IGNITION | pink | + | ignition harness *1 |
| ACCESSORY | orange | + | ignition harness *1 |
| SECOND ACCESSORY | green | + | ignition harness *1 |
| TACHOMETER | white | | ignition coil |
| POWER LOCK | ORANGE / black | *2 | gray 24-pin plug @ BCM *3 |
| POWER UNLOCK | same wire as lock | - | gray 24-pin plug @ BCM *3 |
| PARKING LIGHTS + | do NOT use | | |
| PARKING LIGHTS - | white *8 | | pink 24-pin plug @ BCM *3 |
| DOOR TRIGGER | *5 | - | gray 16-pin plug @ BCM *3 |
| HEADLIGHTS | yellow | - | gray 24-pin plug @ BCM *3 |
| WIPERS | | | |
| LF WINDOW UP/DN | blue - brown | A | drivers window switch |
| RF WINDOW UP/DN | lt. blu - tan | A | drivers door harness |
| LR WINDOW UP/DN | green - purple | A | drivers door harness |
| RR WINDOW UP/DN | lt. grn - purple | A | drivers door harness |
| TRUNK/HATCH PIN | RED / black | - | gray 24-pin plug @ BCM *3 |
| HOOD PIN | none | | |
| TRUNK/HATCH RELEASE | black | - | release switch |
| FACTORY ALARM ARM | none | | |
| FACTORY ALARM DISARM | lt green | - | gray 16-pin plug @ BCM *3 |
| HORN TRIGGER | black *6 | - | steering column |
| BRAKE WIRE | white | + | brake switch |
| LOCK MOTOR | *4 | | |
| UNLOCK MOTOR | *4 | | |
| DISARM DEFEAT | *4 | | |
| DISARM NO UNLOCK | none | | |
| DOME SUPERVISION | use door trigger | | |
| SPEED SENSE | green | | gray 16-pin plug @ BCM *3 |
| SUN ROOF OPEN/CLOSE | | | |
| SUN ROOF LIMIT | | | |
| LF SPEAKER | none | | |
| RF SPEAKER | none | | |
| LR SPEAKER | none | | |
| RR SPEAKER | none | | |
| RADIO 12V | none | | |
| RADIO GROUND | none | | |
| RADIO SWITCH | none | | |
| RADIO ILLUMINATE | none | | |
| POWER ANTENNA | none | | |
| |
| Notes: | NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555t or 555L. *1 The ignition harness is located far right of the steering column, behind the ignition switch. *2 Lock and unlock use the same wire. Lock requires a negative trigger with a 470 ohm resistor in-line. Unlock is negative trigger. Must use relays. *3 The BCM is located above the brake pedal. It is a plastic box with three plugs that face the firewall. *4 Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts. *5 The drivers door trigger wire is blue. Blue/white will catch the passenger door. Use both wires and diode isolate each. *6 Horn can also be found at the black plug with a blue insert above the gas pedal. *7 This wire must be powered as an accessory wire. If powered as an 2nd ignition the car will not crank. *8 Must isolate this wire from the BCM when doing remote start to avoid 'service engine soon' light. See directfax document #1600 for wiring information. |
Follow the12volt.com
Friday, April 19, 2024
• Copyright © 1999-2024 the12volt.com, All Rights Reserved
• Privacy Policy & Use of Cookies
Disclaimer:
*All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please
verify all wire colors and diagrams before applying any information.
Topic Closed)
Members
Search
Register
Login
Printable version
