Viper 791xv

Home / the12volt's Install Bay / Car Security and Convenience / Viper 791xv (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Page < Prev Topic Next Topic >

sroth140

Silver - Posts: 513

Joined: August 27, 2003

Location: United States

Posted: February 02, 2005 at 2:05 PM / IP Logged

um... it should just flip the unlock icon to lock, flash tx/rx, and say arm.

does it beep for lock then a second later beep again and flash 1,2? if its doing that it means the zones were still active and will not arm until they become deactive. this is most commonly due to a vehicle with a dome light delay or the installer not installing a diode between seperate triggers.

MECP certified installer

Back to Top

grtn316

Member - Posts: 44

Joined: February 01, 2005

Location: United States

Posted: February 02, 2005 at 2:15 PM / IP Logged

it locks, flashes tx/rx, says arm.

It was in vibrate mode... I push lock, it vibrates. Then a second or 2 later it vibrates again and flashes 1 and 2 with the word sensor below it. My vehicle has a dome light delay for about 15 seconds. When it becomes active, should beep me to let me know its active? Also, can you read my post above the one you just read, and help me out with that? Thanks!

Back to Top

mobile1

Silver - Posts: 479

Joined: February 23, 2004

Location: United States

Posted: February 06, 2005 at 8:33 AM / IP Logged

it sounds like the sensor is mounted/secured poorly. i doubt the harness is "backwards". across the harness there is 12v, full trigger, warn away, and status/ground.

The trigger wires in shock sensor's harness are multiplexed. on one end of the harness there is an open wire, on the other end there is a looped wire. the looped end of the plug must be at the shock sensor or you will not have a warn away. If you don't believe me call DEI. I had this problem in the past and called their tech support. they told me to flip the harness around and bingo, worked fine.

Back to Top

mobile1

Silver - Posts: 479

Joined: February 23, 2004

Location: United States

Posted: February 06, 2005 at 8:34 AM / IP Logged

sorry i was quoting sroth at the begining

Back to Top

< Prev Page

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Viper 791xv

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.