the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2005 Sequoia door triggers / hood pin


Post ReplyPost New Topic
< Prev Topic Next Topic >
f00dstamps 
Copper - Posts: 132
Copper spacespace
Joined: December 24, 2004
Location: United States
Posted: February 04, 2005 at 6:00 PM / IP Logged  
what is the easiest way to do this? the wiring diagram i have tells me to get the 4 wires from the module above the driver's kick panel.
the plugs were nearly impossible to take out and i was trying to remove the entire module but there is no room to slide it down towards the kick panel after i remove the bolt.
how have others done the door trigger?
there is no place to install the hood pin without having to drill into the frame. i know there is a hood pin wire on the ecu but i was having a hard time finding it.
please advise.
jandjav 
Member - Posts: 13
Member spacespace
Joined: October 28, 2004
Posted: February 05, 2005 at 1:14 AM / IP Logged  
   PRINTABLE VERSION
  TOYOTA
  
 MODEL YEAR(S)
 SEQUOIA  2004 -2005
 KEY T-HARNESS IMMOBILIZER
  N/A   N/A   791 BYPASS MODULE and EXTRA IGNITION KEY
 PART  COLOR LOCATION DIAGRAM
 12 VOLT CONSTANT  WHITE/ RED & WHITE/ BLUE (+)   IGNITION SWITCH HARNESS  
 STARTER BLACK/ WHITE (+)  IGNITION SWITCH HARNESS  
 STARTER 2 N/A  
 IGNITION 1 BLACK/ RED (+) IGNITION SWITCH HARNESS 
 IGNITION 2 BLACK / YELLOW (+) IGNITION SWITCH HARNESS  
 IGNITION 3 N/A    
 ACCESSORY /HEATER BLOWER 1 PINK (+)  IGNITION SWITCH HARNESS  
 ACCESSORY /HEATER BLOWER 2 N/A    
 KEYSENSE YELLOW /GREEN (-)  IGNITION SWITCH HARNESS  
 PARKING LIGHTS ( - ) GREEN (-)  @ HEADLIGHT SWITCH  
 PARKING LIGHTS ( + ) GREEN (+)  @ HEADLIGHT SWITCH  
 POWER LOCK SEE DIAGRAM     26500_SEQUOIA_TOYOTA and LEXUS door lock interface.pdf
 POWER UNLOCK SEE DIAGRAM    
 DOOR TRIGGER SEE NOTES*     14301_SEQUOIA_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
 DOMELIGHT SUPERVISION WHITE (-)  IN DRIVERS KICK PANEL  
 TRUNK RELEASE N/A    
 SLIDING POWER DOOR N/A    
 HORN BLACK / YELLOW (-)  @ STEERING COLUMN  
 TACH YELLOW /GREEN (-)  @ COIL PACK  
 WAIT TO START LIGHT N/A    
 BRAKE GREEN / WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL  
 FACTORY ALARM DISARM  DISARMS with KEYSENSE wire    
 ANTI-THEFT TRANSPONDER  @ IGNITION SWITCH TUMBLER  
 EXTRA INFORMATION
 * TWO DRIVER SIDE DOOR TRIGGER WIRES ARE IN A 14 PIN PLUG IN THE DRIVER KICK PANEL. DRIVER DOOR TRIGGER IS GRAY/RED IN PIN 14 , THE LEFT REAR DOOR IS RED / WHITE IN PIN 13 . THE TWO PASSENGER SIDE DOOR TRIGGER WIRES ARE IN A 14PIN PLUG IN THE PASSENGER KICK PANEL . THE FRONT PASSENGER DOOR IS GREEN/ BLACK IN PIN 14, AND THE RIGHT REAR DOOR IS RED / WHITE IN PIN 5 . USE ALL FOUR AND DIODE ISLOATE EACH
 LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2
       
f00dstamps 
Copper - Posts: 132
Copper spacespace
Joined: December 24, 2004
Location: United States
Posted: February 05, 2005 at 1:22 AM / IP Logged  
yes, thanks jandjav! wires in the kick panel are kickass. easy to get to. i was starting to wonder how anyone did the door triggers on that module above the fusebox.
anyone know a good place to access the factory hoodpin?
jandjav 
Member - Posts: 13
Member spacespace
Joined: October 28, 2004
Posted: February 05, 2005 at 1:36 AM / IP Logged  
can you trace the hood pin switch wire back
f00dstamps 
Copper - Posts: 132
Copper spacespace
Joined: December 24, 2004
Location: United States
Posted: February 05, 2005 at 1:37 AM / IP Logged  
the car has a stock hoodpin but i haven't found it yet. do you know what area it's located at?
jandjav 
Member - Posts: 13
Member spacespace
Joined: October 28, 2004
Posted: February 05, 2005 at 1:41 AM / IP Logged  
if you will send me your e-mail. i will send you a detailed pic of the door triggers
jandjav 
Member - Posts: 13
Member spacespace
Joined: October 28, 2004
Posted: February 05, 2005 at 1:44 AM / IP Logged  
your local dealer should tell you, look around the hood hinges along the firewall
f00dstamps 
Copper - Posts: 132
Copper spacespace
Joined: December 24, 2004
Location: United States
Posted: February 14, 2005 at 5:12 PM / IP Logged  
jandjav,
i got the door triggers working. i used the 2 driver's side triggers in the driver's kick panel and i used the front door trigger for the passenger side. i could not get the RED / white passenger rear door trigger to work. when the door was open, it wouldn't go to ground all the way. also, it would think a door was open even when the door was closed. i resolved this problem by running a wire directly from the door pin. it wasn't that difficult and just required removing the door sills and running a longer wire.
also, for the hoodpin, i went to a local hardware store and got a L bracket from the hinge department. all i had to do was drill a bigger hole for the door pin switch and bolt the entire hinge to the side of the engine bay.
thanks for your help.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer