the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

LOC Questions


Post ReplyPost New Topic
< Prev Topic Next Topic >
tenny 
Copper - Posts: 66
Copper spacespace
Joined: September 26, 2004
Location: Canada
Posted: April 01, 2005 at 8:05 AM / IP Logged  

1. Are all LOC's created equal? I've found one at canadian tire made by american international model LC-300. It onlyoutputs 1 volt though, is this going to be enough to drive an amp? it says it does but i'm not so sure!

2. When installing an LOC what is the best way to set the gain?

3. Installation instructions say to run speaker wire to the trunk, then mount them by the amp. But is there anything wrong with mounting them under the dash? I've already run a set of RCA's back to the trunk from when I had my aftermarket deck. It died and I dont want to buy a new one since I lost all my chimes and the harness to keep the chimes is not cheap!

4. What will sound better, a CHEAP aftermarket deck like a Koss or Legacy, Pyle, etc or the factory cd player with a LOC? it's a 2004 Oldsmobile Alero.

ss-installer 
Silver - Posts: 444
Silver spacespace
Joined: February 27, 2005
Location: United States
Posted: April 01, 2005 at 8:25 AM / IP Logged  
what amp and subs are you running? if using an LOC you should put it behind the deck. does your amp have high level imput? if so, you could have saved some money by not needing the LOC or the RCAs.
tenny 
Copper - Posts: 66
Copper spacespace
Joined: September 26, 2004
Location: Canada
Posted: April 01, 2005 at 8:30 AM / IP Logged  

It's a Power Acoustic LT720, unfortunately it does not have high level inputs :( In my Camaro I have a Rockford Fosgate 4 channel amp with the high level inputs, but I dont really want to switch the amps since its a higher end system in that car.

And I dont want to have to run all new speaker wire.

No Sub, I am using the LT720 to power Phoenix Gold 5.25" door speakers and Boston Acoustic 6x9's in the rear. It's a 2004 Alero that I drive about 130 miles a day for work so I do not want a sub in it. The main reason for doing it is that the phoenix gold speakers are getting distorted really easily with the factory deck, the amp has a built in crossover that I want to take advantage of before I ruin the speakers.

at the moment everything is wired up for an aftermarket deck, but my kenwood crapped out on me so I want to just go with the factory deck.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, April 23, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer