spacer spacer spacer spacer

first sub box pix

Post ReplyPost New Topic
< Prev Topic Next Topic >
Member - Posts: 14
Member spacespace
Joined: April 14, 2005
Location: United States
Posted: June 26, 2005 at 8:33 PM / IP Logged  
I just left the staples in until I got the first layer of FG laid down then took a Dremel with cutting disk and went around the inside wall of the ring. When I was glassing I tried not to glob too much resin into the countersink and it really came out pretty easy, pulling most of the 1/4" staples with it.
After seeing Parts Express wanted $40+ for a circle jig consisting of a flat piece of plastic, I figured I could make my own. I used a shower stall liner for it's stiffness and then measured from bit to a place, anyplace, on the plastic and made a pivot hole. For the countersink I just made it 3/4" smaller than the outside ring and woodglued them together.
first sub box pix - Page 3 - Last Post -- posted image.
Page of 3

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Follow Follow on Facebook
Monday, January 17, 2022 • Copyright © 1999-2022, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo spacer spacer spacer
Top spacer spacer