Plymouth door locks

I have installed the deluxe model 500 remote starter on my 98 plymouth voyager. I tried the schematic on your site but the locks still fail. I wired the unit up as follows: type "B" neg. trigger, BLU/WHT (unlock) with diode to a 250 ohm resistor then to the vehicle WHT/GRN then GRN/WHT (lock) with diode to a 1.5 K resistor to WHT/GRN vehicle. Locks do not function. The unit clicks, nothing happens. Any help would be appreciated.

*** Single Wire Door Lock System, WHITE/ D GREEN Wire Requires Chassis Ground Thru A 1.5K Ohm Resistor To Lock And Chassis Ground Thru A 249 Ohm Resistor To Unlock. #217- See Single Wire Resistor Door Lock Diagram.Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Have you gotten the diodes reversed...?

Reviewed the website schematic again and it shows:from alarm output to diode to resistor to WHT/GRN vehicle. The diode is in as diagramed. Two other wires from alarm go to vehicle grnd. I thought that by pushhing the lock/unlock button on transmitter would cause the alarm internal relay to supply the required grnd. Does not. I also metered the out put on mod. once the grnd wires are connected. They are labeled 30 to lock/unlock & 87 to grnd. Shouldn't the internal relay in mod. read an open between 30 & 87 while not energized? Once metered it reads continuity to grnd continuous.