2 channel boss amp settings

 have a 760w boss 2 channel boss amp bridged to two 10" MTX thunder 8000 subwoofers.  What are the best settings for high pass, low pass, input, and phase shift.  Be specific please!!eAl

High pass does not matter, it should be on LPF if there is a switch.   the knob for LP should be between 50-100hz.   I prefer below 80hz   the phase shift should be at 0 unless you are interting the subs then set it to 180.    the imput is going to get touchy.   You are not going to get alot of power out of this amp   500watts MAX!   so you are going to be starving the subs for power.   Honestly I would recomend a better amp to run these subs, but if you do decide to use it I would not set the gain over 3/4   you will begin to clip close to there if not before, and that wil lead to a very short life on your subs.     Again I would really suggest a stronger amp, by a brand such as kicker, MTX, JBL, and such2009 0-1000 Trunk WR 154.0DB 2009 1001+ Trunk WR

2007 USACI World Champion

2007 World Record

2006 USACI Finals 2nd Place

Great advice Jeff. I doubt a Boss amp rated at 760 watts will do 500 watts, unless its peak power, which it might hit once a month or so..'85 Toy

I thought a 760 watt amp meant 760 watts!  what's the deal?  please clarify!!!!     What wattage amp would be good for my subs and what's a quaity amp for a fair price?eAl

just because it says 760 does not mean it can do it. Boss never reports the right specs. they always over rate there stuff. all cheap amp companies do that. thats why it was suggested to go with a name that has a good reputation.

That amp likely is 760 watts max, so most likely your looking at 380 or so RMS.2003 Chevrolet Silverado Standard Cab ~ Alpine CDA-9851

Diamond Audio D3600.1 ~ 2x Diamond Audio TM310D4

Diamond Audio D3400.4 ~ Diamond Audio Hex S600s

AstroStart RS5204 Remote Start/Alarm

What model is your amp?Support the12volt.com