2006 jeep liberty, alarm w/keyless wiring

looking for wiring diagram to install car alarm w/keyless entry....vehicle has keyless on key, but want  to add actual alarm system to vehicle.  can anyone help???football fanatic

12 volt    -red              @ignition harness ignition   -pink/lt green starter    -lt blue/red dome light -driver door violet 26 pin gray conn            -front right violet/white            -rear left   violet/gray 22 pin gray conn            -rear right violet / YELLOW all above(-) door trigger wires at bcm-behinddriver dash left of steering column.diode isolate,band side faces oem wires. trunk/hatch -violet / YELLOW gray 26pin coo at bcm. park lights -pink/red(-)steering column harness,use relay-must see ground thru 900 ohm resistor power lock/unlock -tan/blue single wire,42 pin green conn @junction block chassis ground thru 1.4k ohm resistor to lock,chassis ground thru 425 ohm to unlock. trunk release -lt GREEN / WHITE(-)at bcm conn 1 horn        -dk GREEN/ violet(-) steering column harn. tach -black any injector ign 2 -pink / YELLOW test for correct one,2wires present. accessories-pink / YELLOW    brake light -WHITE/ tan(+)at switch above brake pedal vehicle has immobilizer on key,use bypass