the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

01 Dodge Dakota alarm wiring


Post ReplyPost New Topic
< Prev Topic Next Topic >
preludeofdesire 
Member - Posts: 1
Member spacespace
Joined: January 28, 2006
Location: United States
Posted: January 28, 2006 at 6:54 AM / IP Logged  
I am looking for the wires needed to install an alarm on my 01 Dodge Dakota.  It will be just the alarm for now cause I don't have power locks.  I might add on but as of right now I don't have it.  If anyone can help I would apreciate it.
notoriouswill 
Member - Posts: 32
Member spacespace
Joined: January 28, 2006
Location: United States
Posted: January 29, 2006 at 1:33 PM / IP Logged  
12volts pnk/blk & RED / lt blu   +  ignition harness
Starter yellow   +  ignition harness
Ignition blue   +  ignition harness
Power Lock WHITE/ green  -  conn. 2, pin 10 @ CTM
Notes: Lock is negative trigger thru a 820 ohm resistor. Unlock is negative trigger thru a 330 ohm resistor. MUST use relays.
The Central Timer Module is in the driver kick panel.
Power Unlock same wire    
Lock Motor ORANGE / black    conn. 2, pin 4 @ CTM
Notes: The Central Timer Module is in the driver kick panel.
Unlock Motor blue (4 dr only)    conn. 2, pin 6 @ CTM
Notes: The 2 door models do not have progressive unlock on the factory keyless.
The Central Timer Module is in the driver kick panel.
Disarm Defeat pink/black    conn. 2, pin 5 @ CTM
Notes: The Central Timer Module is in the driver kick panel.
Parking Lights+ BLACK / YELLOW    headlight switch
Parking Lights- RED / yellow    conn. 1, pin 4 @ CTM
Notes: The Central Timer Module is in the driver kick panel.
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Door Trigger    -  CTM
Notes: The driver door trigger is tan in connector 2, pin 15. The passenger door trigger (and rears on the 4dr) is tan/red in connector 2, pin 13. Use both and diode isolate each. See directfax document #1076 for wiring information.
The Central Timer Module is in the driver kick panel.
Dome Supervision use door trigger    
Trunk/Hatch Pin     
Hood Pin     
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm lt. GREEN/ orange  -  conn. 2, pin 14 @ CTM
Notes: Arm is negative trigger thru a 644 ohm resistor. Disarm is negative trigger thru a 1565 ohm resistor. MUST use relays. This wire will also lock the doors, and it will unlock with a double pulse.
The Central Timer Module is in the driver kick panel.
Factory Alarm Disarm same wire    
Disarm No Unlock     
Tachometer     ignition coil
Notes: On the 2.5L/3.9L/5.9L models use BLACK/ gray at the ignition coil. The 4.7L models have an ignition coil for each cylinder, use the wires that is NOT GREEN/ orange at one of the coils.
Horn Trigger BLACK/ red   -  steering column or CTM
Notes: The Central Timer Module is in the driver kick panel.
1 Memphis Mojo 15
1 Memphis 4000 watt amp
1 Memphis 75watt 4 channel amp
2 Memphis 6.5" MSQ's
01 Dodge Dakota alarm wiring - Last Post -- posted image.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer